DC482A: Demo Board for the LTC1983 100mA Regulated Charge-Pump Inverters in ThinSOT.

DC489A-A: Demo Board for the LTC5507 100kHz to 1GHz RF Power Detector.

The LTC3413 is a high efficiency monolithic synchronous step-down DC/DC converter utilizing a constant frequency, current mode architecture. It operates from an input voltage range of 2.25V to 5.5V and provides a regulated output voltage equal to (0.5)VREF while sourcing or sinking up to 3A of output current. An internal voltage divider reduces component count and eliminates the need for external resistors by dividing the reference voltage in half. The internal synchronous power switch with 85m? on-resistance increases efficiency and eliminates the need for an external Schottky diode. Switching frequencies up to 2MHz are set by an external resistor.Forced-continuous operation in the LTC3413 reduces noise and RF interference. Fault protection is provided by an overcurrent comparator that limits output current during both sourcing and sinking operations. Adjustable compensation allows the transient response to be optimized over a wide range of loads and output capacitors.Applications Bus Termination: DDR and QDR? Memory, SSTL, HSTL, ... Notebook Computers Distributed Power Systems

The LTC4006 is a complete constant-current/constant voltage charger controller for 2-, 3- or 4-cell lithium batteries in a small package using few external components. The PWM controller is a synchronous, quasi-constant frequency, constant off-time architecture that will not generate audible noise even when using ceramic capacitors.The LTC4006 is available in 8.4V, 12.6V and 16.8V versions with ?0.8% voltage accuracy. Charging current is programmable with a single sense resistor to ?4% typical accuracy. Charging current can be monitored as a representative voltage at the IMON pin. A timer, programmed by an external resistor, sets the total charge time or is reset to 25% of total charge time after C/10 charging current is reached. Charging automatically resumes when the cell voltage falls below 3.9V/cell.Fully discharged cells are automatically trickle charged at 10% of the programmed current until the cell voltage exceeds 2.5V/cell. Charging terminates if the low-battery condition persists for more than 25% of the total charge time.The LTC4006 includes a thermistor sensor input that suspends charging if an unsafe temperature condition is detected and automatically resumes charging when the battery temperature returns to within safe limits.Applications Notebook Computers Portable Instruments Battery-Backup Systems Standalone Li-Ion Chargers

The LTC3406 is a high efficiency monolithic synchronous buck regulator using a constant frequency, current mode architecture. The device is available in an adjustable version and fixed output voltages of 1.5V and 1.8V. Supply current during operation is only 20?A and drops to <=1?A in shutdown. The 2.5V to 5.5V input voltage range makes the LTC3406 ideally suited for single Li-Ion battery-powered applications. 100% duty cycle provides low dropout operation, extending battery life in portable systems. Automatic Burst Mode? operation increases efficiency at light loads, further extending battery life.Switching frequency is internally set at 1.5MHz, allowing the use of small surface mount inductors and capacitors.The internal synchronous switch increases efficiency and eliminates the need for an external Schottky diode. Low output voltages are easily supported with the 0.6V feedback reference voltage. The LTC3406 is available in a low profile (1mm) ThinSOT package.Protected by U.S. Patents, including 6580258, 5481178. ? Vout Fsw Features LTC3406 Adj. 1.5MHz Burst Mode LTC3406-1.2 1.2V 1.5MHz Burst Mode LTC3406-1.5 1.5V 1.5MHz Burst Mode LTC3406-1.8 1.8V 1.5MHz Burst Mode LTC3406B Adj. 1.5MHz Burst Mode Disabled LTC3406B-1.2 1.2V 1.5MHz Burst Mode Disabled LTC3406B-2 Adj. 2.25MHz Burst Mode Disabled LTC3406A Adj. 1.5MHz Low Ripple Burst Mode LTC3406AB Adj. 1.5MHz Burst Mode Disabled LTC3406AB-2 Adj. 2.25MHz Burst Mode Disabled Applications Cellular Telephones Personal Information Appliances Wireless and DSL Modems Digital Still Cameras MP3 Players Portable Instruments

DC503A: Demo Board for the LT5512 1kHz-3GHz High Signal Level Active Mixer.

The LTC3251/LTC3251-1.2/LTC3251-1.5 are 2-phase charge pump step-down DC/DC converters that produce a regulated output from a 2.7V to 5.5V input. The parts use switched capacitor fractional conversion to achieve twice the typical efficiency of a linear regulator. No inductors are required. VOUT is resistor programmable from 0.9V to 1.6V or fixed at 1.2V or 1.5V, with up to 500mA of load current available.A unique 2-phase spread spectrum architecture provides a very low noise regulated output as well as low noise at the input. The parts have four operating modes: Continuous Spread Spectrum, Spread Spectrum with Burst Mode operation, Super Burst? mode operation and shutdown.Low operating current (35?A in Burst Mode operation, 10?A in Super Burst mode operation) and low external parts count make the LTC3251/LTC3251-1.2/LTC3251-1.5 ideally suited for space-constrained battery-powered applications. The parts are short-circuit and over-temperature protected, and are available in a thermally enhanced 10-pin MSOP package.Applications Handheld Devices Cellular Phones Portable Electronic Equipment DSP Power Supplies

The LTC3729 is a multiple phase, synchronous step-down current mode switching regulator controller that drives N-channel external power MOSFET stages in a phase-lockable fixed frequency architecture. The PolyPhase controller drives its two output stages out of phase at frequencies up to 550kHz to minimize the RMS ripple currents in both input and output capacitors. The output clock signal allows expansion for up to 12 evenly phased controllers for systems requiring 15A to 200A of output current. The multiple phase technique effectively multiplies the fundamental frequency by the number of channels used, improving transient response while operating each channel at an optimum frequency for efficiency. Thermal design is also simplified.An internal differential amplifier provides true remote sensing of the regulated supply?s positive and negative output terminals as required for high current applications.A RUN/SS pin provides both soft-start and optional timed, short-circuit shutdown. Current foldback limits MOSFET dissipation during short-circuit conditions when the overcurrent latchoff is disabled. OPTI-LOOP compensation allows the transient response to be optimized over a wide range of output capacitance and ESR values. The LTC3729 includes a power good output pin that indicates when the output is within ?7.5% of the designed set point. Vin Max Vref LTC3729 36V 0.8 LTC3729L-6 30V 0.6 Applications Desktop Computers Large Memory Arrays DC Power Distribution Systems

The LTC2846 is a 3-driver/3-receiver multiprotocol transceiver with on-chip cable termination. When combined with the LTC2844 or LTC2845, this chip set forms a complete software-selectable DTE or DCE interface port that supports the RS232, RS449, EIA530, EIA530-A, V.35, V.36 and X.21 protocols. All necessary cable termination is provided inside the LTC2846. The LTC2846 has a boost regulator that takes in a 3.3V input and switches at 1.2MHz, allowing the use of tiny, low cost capacitors and inductors 2mm or less in height.The 5V output drives an internal charge pump that requires only five space-saving surface mounted capacitors. The LTC2846 is available in a 36-lead SSOP surface mount package.Applications Data Networking CSU and DSU Data Routers

DC539A: Demo Board for the LTC5508 300MHz to 7GHz RF Power Detector with Buffered Output in SC70 Package.