DC816A-R: Demo Board for the LTC2286 Dual 10-Bit, 25Msps Low Noise 3V ADCs.

DC824A: Demo Board for the LTC3208 High Current Software Configurable Multidisplay LED Controller.

DC829A: Demo Board for the LTC3776 - Dual 2-Phase, No RSENSE Synchronous Controller for DDR/QDR Memory Termination.

The LT1952/LT1952-1 are current mode PWM controllers optimized to control the forward converter topology, using one primary MOSFET. The LT1952/LT1952-1 provide synchronous rectifier control, resulting in extremely high efficiency. A programmable Volt-Second clamp provides a safeguard for transformer reset that prevents saturation. This allows a single MOSFET on the primary side to reliably run at greater than 50% duty cycle for high MOSFET, transformer and rectifier utilization. The devices include soft-start for controlled exit from shutdown and undervoltage lockout. A precision 107mV current limit threshold, independent of duty cycle, combines with softstart to provide hiccup short circuit protection. The LT1952 is optimized for micropower bootstrap startup from high input voltages. The LT1952-1 allows startup from lower input voltages. Programmable slope compensation and leading edge blanking allow optimization of loop bandwidth with a wide range of inductors and MOSFETs. Each device can be programmed over a 100kHz to 500kHz frequency range and the part can be synchronized to an external clock. The error amplifier is a true op amp, allowing a wide range of compensation networks. The LT1952/LT1952-1 are available in a small 16-pin SSOP package.Applications Telecommunications Power Supplies Industrial and Distributed Power Isolated and Non-Isolated DC/DC Converters

The LTC4441/LTC4441-1 is an N-channel MOSFET gate driver that can supply up to 6A of peak output current. The chip is designed to operate with a supply voltage of up to 25V and has an adjustable linear regulator for the gate drive. The gate drive voltage can be programmed between 5V and 8V.The LTC4441/LTC4441-1 features a logic threshold driver input. This input can be driven below ground or above the driver supply. A dual function control input is provided to disable the driver or to force the chip into shutdown mode with <12?A of supply current. Undervoltage lockout and overtemperature protection circuits will disable the driver output when activated. The LTC4441 also comes with an open-drain output that provides adjustable leading edge blanking to prevent ringing when sensing the source current of the power MOSFETs.The LTC4441 is available in a thermally enhanced 10-lead MSOP package. The LTC4441-1 is the SO-8 version without the blanking function.Protected by U.S. Patents including 6677210.Applications Power Supplies Motor/Relay Control Line Drivers Charge Pumps

DC851A-S: Demo Board for the LTC2284 Dual 14-Bit, 105Msps Low Power 3V ADC.

DC851A-V: Demo Board for the LTC2282 Dual 12-Bit, 105Msps Low Power 3V ADC

DC851A-W: Demo Board for the LTC2280 Dual 10-Bit, 105Msps Low Noise 3V ADC.

DC854D-F: Demo Board for the LTC2217 16-Bit, 105Msps Low Noise ADC.

DC854D-H: Demo Board for the LTC2216 16-Bit, 80Msps Low Noise ADC.