DC1370A-N: Demo Board for the LTC2262-12 12-Bit, 150Msps Ultralow Power 1.8V ADC

The LTM4604 is a complete 4A switch mode step-down ?Module? (power module) regulator. Included in the package are the switching controller, power FETs, inductor and all support components. Operating over an input voltage range of 2.375V to 5.5V, the LTM4604 supports an output voltage range of 0.8V to 5V, set by a single resistor. This high efficiency design delivers up to 4A continuous current (5A peak). Only bulk input and output capacitors are needed to complete the design.The low profile package (2.32mm) enables utilization of unused space on the bottom of PC boards for high density point of load regulation. High switching frequency and a current mode architecture enable a very fast transient response to line and load changes without sacrificing stability. The device supports output voltage tracking for supply rail sequencing.Fault protection features include foldback current protection, thermal shutdown and a programmable soft-start function. The LTM4604 is offered in a RoHS compliant 15mm ? 9mm ? 2.32mm LGA package.For easier PC board layout and assembly due to increased spacing between land grid pads, please refer to the LTM4604A. Notes LTM4604 - LTM4604A Smaller pad sizes provide more distance between adjacent pads therefore there is less chance of solder paste or solder spreading outside the pad area. APPLICATIONS Telecom and Networking Equipment Servers, ATCA Cards Industrial Equipment

DC1384A-A: Demo Board for the LTC2452 Ultra-Tiny, Differential, 16-Bit ∆Σ ADC with SPI Interface

Demonstration circuits 1387A-A and A-B are Ultralow Power Boost Converters with Output Disconnect featuring the LT8410 and LT8410-1. Both versions convert a 3V-10V source. The -A version supplies 1.6mA at 3VIN and the -B supplies 0.5mA Both versions feature a low noise variable off-time and variable peak current control scheme, integrated Schottky diode and output disconnect function, ultralow quiescent current, built-in soft-start and overvoltage protection.

Demonstration circuit DC1409 is DC/DC boost converter featuring the LTC3788 constant frequency current mode boost controller. The DC1409A operates over 5V to 24V input and provides 8A to 10A of output current at 12V output. Also, the DC1409A provides a second 24V output capable of delivering 3A to 5A. The 300kHz constant frequency operation results in small and efficient circuit. The converter provides high output voltage accuracy (typically ±3%) over wide load range with no minimum load requirement. The demonstration circuit can be easily modified to generate different output voltages. Also, the two outputs can be connected together to generate single output with two phase operation.

DC1418A-A: Demo Board for the LT6604-2.5 Dual Very Low Noise, Differential Amplifier and 2.5MHz Lowpass Filter.

DC1418A-B: Demo Board for the LT6604-5 Dual Very Low Noise, Differential Amplifier and 5MHz Lowpass Filter.

DC1418A-C: Demo Board for the LT6604-10 Dual Very Low Noise, Differential Amplifier and 10MHz Lowpass Filter.

DC1431A-A: Demo Board for the LTC5540 600MHz to 1.3GHz High Dynamic Range Downconverting Mixer.

DC1431A-B: Demo Board for the LTC5541 1.3GHz to 2.3GHz High Dynamic Range Downconverting Mixer.