DC805A: Demo Board for the LTC3216 1A Low Noise High Current LED Charge Pump with Independent Torch/Flash Current Control.

LED Driver DSL Modems Distributed Power Input/Output Current Limited Boost, SEPIC,

in a thermally enhanced 16-pin TSSOP package.Applications High Power LED Driver DSL Modems Distributed Power

DC871A-A: Demo Board for the LTC3215 700mA Low Noise High Current LED Charge Pump.

DC902A-B: Demo Board for the LTC3214 500mA Camera LED Charge Pump.

current over a wide programmable range. Series connection of the LEDs provides identical LED currents for

Demonstration circuit 976 is a Quadruple High Power LED Driver in Buck Mode featuring the

Demonstration circuit 1294A exercises four adjustable linear regulators in parallel using the LT3080. A small 20 mΩ ballast resistor is required for parallel operation. A short PCB trace can easily serve that purpose. The paralleled devices provide up to 4.4A of output current at 3.3V. Architected as a precision current source and voltage follower, the LT3080 can be used in many applications requiring high current, adjustability to zero output, and no heat sink. The device brings out the collector of the pass transistor to allow low dropout operation when used with multiple supplies. The LT3080's output voltage can be programmed to any level between 0V and 36V; however the demo board has a reduced input voltage range from 3.8V to 25V due to the input capacitor voltage rating.

3000:1 LED dimming on each channel. Each of the three channels has a built-in gate driver to drive an

Demonstration circuit 1590B is a dual output synchronous buck converter featuring the LTC3880EUJ, a dual output peak current mode controller with digital power system management. There are two versions of the board available: DC1590B-A senses the output current across a sense resistor and has a default switching frequency of 350kHz, and DC1590B-B senses output current with the inductor DCR and has a default switching frequency of 425kHz. Either version can be populated with the LTC3880EUJ-1 (which allows the user to provide bias power to the IC from an external power supply) instead of the LTC3880EUJ. These boards provide two programmable outputs of 20A each. The factory default settings are 1.8V for each output.