48-Port IEEE802.3bt (PoE 2) PSE Digital Controller Features: Fully Compliant IEEE 802.3bt Type 3 and 4 PSE Fully Compliant IEEE 802.3at Type 2 PSE Software-Compatible with LTC4291-1/LTC4292 Up to 48 PSE Ports with One Power Channel per Port Up to 24 PSE Ports with Two Power Channels per Port ECC-Protected eFlash and Data RAMs Low Power Path Dissipation per Channel 100mΩ Sense Resistance 30mΩ or Lower MOSFET RDS(ON) Chipset Provides Electrical Isolation Eliminates Optos and Isolated 3.3V Supply Very High Reliability Multipoint PD Detection Connection Check Distinguishes Single-Signature and Dual-Signature PDs Continuous Per-Port Power and Current Monitoring 1MHz I2C Compatible Serial Control Interface Pin or I2C Programmable PD Power Available in 24-Lead 4mm × 4mm (LTC91011) and a 64-Lead 7mm × 11mm (LTC9102/LTC9103) QFN Packages

EVALUATION KIT, LOW NOISE AMPLIFIER;

EVALUATION KIT, 1MHZ, 3-5.5V;

MAX97003 series 1-Channel (Mono) with Stereo Headphones Output Class D, Class H Audio Amplifier Evaluation Board

MAX16126 Circuit Protection Power Management Evaluation Board

MAX77961B - Special Purpose DC/DC, Charger 1, Non-Isolated Outputs Evaluation Board

MAX77960B - Special Purpose DC/DC, Charger 1, Non-Isolated Outputs Evaluation Board

EVALUATION KIT, 12-BIT D/A CONVERTER;

MAX17633 - DC/DC, Step Down 1, Non-Isolated Outputs Evaluation Board

The MAX7030 crystal-based, fractional-N transceiver is designed to transmit and receive ASK/OOK data at factory-preset carrier frequencies of 315MHz or 433.92MHz with data rates up to 33kbps (Manchester encoded) or 66kbps (NRZ encoded). This device generates a typical output power of +10dBm into a 50Ω load and exhibits typical sensitivity of -114dBm. The MAX7030 features separate transmit and receive pins (PAOUT and LNAIN) and provides an internal RF switch that can be used to connect the transmit and receive pins to a common antenna.The MAX7030 transmit frequency is generated by a 16-bit, fractional-N, phase-locked loop (PLL), while the receiver's local oscillator (LO) is generated by an integer-N PLL. This hybrid architecture eliminates the need for separate transmit and receive crystal reference oscillators because the fractional-N PLL is preset to be 10.7MHz above the receive LO. Retaining the fixed-N PLL for the receiver avoids the higher current-drain requirements of a fractional-N PLL and keeps the receiver current drain as low as possible. All frequency generationcomponents are integrated on-chip, and only a crystal, a 10.7MHz IF filter, and a few discrete components are required to implement a complete antenna/digital data solution.The MAX7030 is available in a small, 5mm × 5mm, 32-pin thin QFN package, and is specified to operate over the automotive -40°C to +125°C temperature range.Applications2-Way Remote Keyless EntryGarage Door OpenersHome AutomationLocal Telemetry SystemsRemote ControlsRemote SensingSecurity SystemsSmoke Alarms