Precision Amplifiers Dual Low Voltage Low Power CMOS OPAMP

Operational Amplifiers - Op Amps 18V, 22 A, 45nV/?Hz, RRIO, Dual Op Amp

Digital to Analog Converters - DAC ual 10Bit D/A, in MSOP, I2C Interface

2.5 V to 5.5 V, 250 A, 2-Wire Interface, Dual Voltage Output, 10-Bit DACs Features: AD5337: 2 buffered 8-bit DACs in 8-lead MSOP AD5338, AD5338-1: 2 buffered 10-bit DACs in 8-lead MSOP AD5339: 2 buffered 12-bit DACs in 8-lead MSOP Low power operation: 250 μA @ 3 V, 300 μA @ 5 V 2-wire (I2C-compatible) serial interface 2.5 V to 5.5 V power supply Guaranteed monotonic by design over all codes Power-down to 80 nA @ 3 V, 200 nA @ 5 V 3 power-down modes Double-buffered input logic Output range: 0 V to VREF Power-on reset to 0 V

UCD3138A Highly Integrated Digital Controller for Isolated Power 40-WQFN -40 to 125

UCD3138A Highly Integrated Digital Controller for Isolated Power

Low Power, Unity Gain Fully Differential Amplifier & ADC Driver Features: Very low power - 330 μA supply current Fully differential or single-ended inputs/outputs Differential output designed to drive precision ADCs - Drives switched capacitor and Σ-Δ ADCs - Rail-to-rail output VOCM pin adjusts output common mode Robust overvoltage up to 18 V beyond supplies High performance - Suitable for driving 16-bit converter up to 250 kSPS - 39 nV/√Hz output noise - 1 ppm/°C gain drift - 200 μV maximum output offset - 10 V/μs slew rate - 5 MHz bandwidth Single supply: 3 V to 18 V Dual supplies: ±1.5 V to ±9 V

Low Power, Wide Supply Range, Low Cost Difference Amplifiers, G = , 2 Features: Wide input range beyond supplies Rugged input overvoltage protection Low supply current: 200 μA maximum (per amplifier) Low power dissipation: 0.5 mW at VS = 2.5 V Bandwidth: 1 MHz (G = ½) CMRR: 80 dB minimum, dc to 20 kHz (G = ½, B Grade) Low offset voltage drift: ±1 μV/°C maximum (B Grade) Low gain drift: 1 ppm/°C maximum (B Grade) Enhanced slew rate: 1.4 V/μs Wide power supply range Single supply: 2 V to 36 V Dual supplies: ±2 V to ±18 V 8-lead SOIC, 14-lead SOIC, and MSOP packages

Low Power, Rail-to-Rail Output, Precision Dual JFET Op Amp Features: Low Supply Current: 250 µA max Very Low Input Bias Current: 1 pA max Low Offset Voltage: 750 µV max Single-supply Operation: 5 V to 26 V Dual-supply Operation: ±2.5 V to ±13 V Rail-to-rail Output Unity Gain Stable No Phase Reversal

Single-Supply, Low Cost Instrumentation Amplifier