5.9 GHz to 23.6 GHz, Wideband, Microwave Upconverter Features: Wideband RF output frequency range: 5.9 GHz to 23.6 GHz Two upconversion modes Direct conversion from baseband I/Q to RF Single sideband upconversion from real IF LO input frequency range: 5.4 GHz to 14 GHz LO doubler for up to 28 GHz Matched 100 Ω balanced RF output, LO input, and IF input High impedance baseband inputs Sideband suppression and carrier feedthrough optimization Variable attenuator and power detector for Tx power control Programmable via 4-wire SPI interface 32-lead, 5 mm × 5 mm LFCSP microwave packaging

Real-Time Ethernet Multiprotocol (REM) Switch Features: 144-lead CSP_BGA RoHS compliant package −40°C to +105°C industrial temperature range rating 3.3 V input/output buffers IEEE 802.3, 10 Mbps/100 Mbps, half and full duplex, IPv6 and IPv4 communication 2 independent Ethernet ports: 1 MII and 1 RMII interface per port Support for all industrial protocols PROFINET Class B and Class C with fast startup (Version 2.3) EtherNet/IP with QuickConnect, CIP Sync, and CIP Motion Modbus TCP EtherCAT Ethernet POWERLINK Host interface transfer rate: 32 bits per 28 ns Supports EtherCAT cycle times down to 12.5 μs and PROFINET cycle times down to 31.25 μs PI Net Load Class III capable DLR (supervisor and node, announce and beacon based), MRPD, HSR, PRP, shared device, controller redundancy IEEE 1588Version 2 support: ordinary clock; both peerto peer and end to end transparent clocks, raw frames, and UDP 8 independent timer signals synchronized with an internal precision timer 4 independently programmable timer signals for timer capture events or timer output events 4 timer signals create programmable periodic waveforms synchronized to the internal precision timer DCP, LLDP, DHCP, RSTP, VLAN, IGMP snooping support Forwarding table with aging and learning Drive LEDs for link activity

Four-ADC, Two-DAC, Low Power Codec with Audio Processor Features: Programmable audio processing engine Fast (up to 768 kHz) and slow processing paths Biquad filters, limiters, volume controls, and mixing Low latency, 24-bit ADCs and DACs 102 dB SNR (through PGA and ADC with A weighted filter) 108 dB combined SNR (through DAC and headphone with A weighted filter) Serial port sampling rate from 8 kHz to 192 kHz 5 μs analog-to-analog latency 4 single-ended analog inputs, configurable as microphone or line inputs Dual stereo digital microphone inputs Stereo analog audio output, single-ended or differential, configurable as either line output or headphone driver PLL supporting any input clock rate from 8 MHz to 27 MHz Full duplex, asynchronous sample rate converters (ASRCs) Power supplies Analog and digital input/output of 1.8 V to 3.3 V Digital signal processing (DSP) core of 1.1 V to 1.8 V Low power I2C and SPI control interfaces, self boot from I2C EEPROM 7 multipurpose (MPx) pins for digital controls and outputs

VIDEO AMPLIFIER;

VIDEO DECODERS;

NON VOLATILE DIGITAL POTENTIOMETER;

VOLTAGE DIGITAL POTENTIOMETER;

SPECIAL FUNCTION IC;

SPECIAL FUNCTION IC;

SPECIAL FUNCTION IC;