High Linearity Differential RF/IF Amplifier/ADC Driver Features: 51.0dBm OIP3 at 240MHz into a 100Ω Diff Load NF = 2.9dB at 240MHz 20MHz to 2060MHz –3dB Bandwidth 20.8dB Gain A-Grade 100% OIP3 Tested at 380MHz 0.6nV/√Hz Total Input Noise S11 < –10dB Up to 1.4GHz S22 < –10dB Up to 1.4GHz >2.75VP-P Linear Output Swing P1dB = 24.0dBm Insensitive to VCC Variation 100Ω Differential Gain-Block Operation Input/Output Internally Matched to 100Ω Diff Single 5V Supply DC Power = 850mW 4mm × 4mm, 24-Lead QFN Package

RF Receiver FM receiver with RDS

2 dB LSB, 4-Bit, Silicon Digital Attenuator, 100 MHz to 40 GHz Features: Ultrawideband frequency range: 100 MHz to 40 GHz Attenuation range: 2 dB steps to 30 dB Low insertion loss 1.7 dB to 18 GHz 2.2 dB to 26 GHz 3.5 dB to 40 GHz Attenuation accuracy ±(0.1 + 2.0%) of attenuation state up to 18 GHz ±(0.2 + 2.5%) of attenuation state up to 26 GHz ±(0.5 + 10.0%) of attenuation state up to 40 GHz High RF input power handling: 26 dBm average, 30 dBm peak Tight distribution in relative phase Typical step error ±0.15 dB to 18 GHz ±0.20 dB to 26 GHz ±0.60 dB to 40 GHz High input linearity P0.1dB insertion loss state: 30 dBm P0.1dB other attenuation states: 26 dBm IP3: 50 dBm typical No low frequency spurious signals SPI and parallel mode control, CMOS/LVTTL compatible RF amplitude settling time (0.1 dB of final RF output): 230 ns 2.5 mm × 2.5 mm, 16-terminal LGA package Pin compatible with ADRF5721, low frequency cutoff version

GaAs, pHEMT, MMIC,1/2 W, 20 GHz to 44 GHz, Power Amplifier Features: Output P1dB: 28 dBm (typical at 34 GHz to 44 GHz) PSAT: 30 dBm (typical at 20 GHz to 34 GHz) Gain: 15 dB (typical at 34 GHz to 44 GHz) IP3: 40 dBm (typical) Supply voltage: 5 V at 600 mA Die size: 2.75 mm × 1.805 mm × 0.1 mm

18 GHz to 44 GHz, GaAs, pHEMT, 32 dBm (>1 W), MMIC Power Amplifier Features:ADPA7005AEHZ Output P1dB: up to 31 dBm typical PSAT: up to 32 dBm typical Gain: up to 15.5 dB typical Output IP3: up to 42.5 dBm typical Supply voltage: 5 V at 1400 mA 50 matched input/output 18-terminal, 7 mm × 7 mm LCC_HS package Integrated power detectorADPA7005CHIP Output P1dB: 31 dBm typical at 20 GHz to 34 GHz PSAT: 32 dBm typical at 20 GHz to 34 GHz Gain: 17 dB typical at 20 GHz to 34 GHz Output IP3: 41 dBm typical at 20 GHz to 34 GHz Supply voltage: 5 V at 1200 mA maximum 50 Ω matched input/output Die size: 3.75 mm × 3.47 mm × 0.1 mm

400MHz Quadrature IF Demodulator with RSSI Features: Single 1.8V to 5.25V Supply IF Frequency Range: 70MHz to 400MHz 84dB Limiting IF Gain 90dB Linear RSSI Range 7.7MHz Lowpass Output Filter Baseband I/Q Amplitude Imbalance: <0.7dB 4dB Noise Figure Low Supply Current: 25mA Outputs Biased Up While in Standby Shutdown Current: 1µA 24-Lead Narrow SSOP Package

High Signal Level Upconverting Mixer Features: Wide RF Output Frequency Range to 3000MHz Broadband RF and IF Operation +17dBm Typical Input IP3 (at 950MHz) +6dBm IF Input for 1dB RF Output Compression Integrated LO Buffer: -10dBm Drive Level Single-Ended or Differential LO Input Double-Balanced Mixer Enable Function Single 4.0V-5.25V Supply Voltage Range 16-Pin TSSOP Exposed Pad Package

Low Distortion IF Amplifier/ADC Driver with Digitally Controlled Gain Features: Output IP3 at 100MHz: 40dBm Maximum Output Power: 16dBm Bandwidth: LF to 540MHz Propagation Delay: 0.8ns Maximum Gain: 27dB Gain Control Range: 22.5dB Gain Control Step: 1.5dB Gain Control Settling Time: 500ns Noise Figure: 8.6dB at 100MHz (Max Gain) Output Noise Floor: –138dBm/Hz (Max Gain) Reverse Isolation: –92dB Single Supply: 4.75V to 5.25V Shutdown Mode Enable/Disable Time: 1µs Differential I/O Interface 20-Lead TSSOP Package

1.5GHz to 2.4GHz High Linearity Direct Quadrature Modulator Features: Direct Conversion to 1.5GHz to 2.4GHz High OIP3: 21.8dBm at 2GHz Low Output Noise Floor at 5MHz Offset: No RF: –159.3dBm/Hz POUT = 4dBm: –151.8dBm/Hz 4-Ch W-CDMA ACPR: –66dBc at 2.14GHz Integrated LO Buffer and LO Quadrature Phase Generator 50Ω AC-Coupled Single-Ended LO and RF Ports 50Ω DC Interface to Baseband Inputs Low Carrier Leakage: –42dBm at 2GHz High Image Rejection: 45dB at 2GHz 16-Lead QFN 4mm × 4mm Package

1.5GHz to 2.5GHz High Linearity Direct Quadrature Modulator Features: Direct Conversion from Baseband to RF High Output: –2.5dB Conversion Gain High OIP3: +21.6dBm at 2GHz Low Output Noise Floor at 20MHz Offset: No RF: –158.6dBm/Hz POUT = 4dBm: –152.5dBm/Hz Low Carrier Leakage: –39.4dBm at 2GHz High Image Rejection: –41.2dBc at 2GHz 4-Channel W-CDMA ACPR: –67.7dBc at 2.14GHz Integrated LO Buffer and LO Quadrature Phase Generator 50Ω AC-Coupled Single-Ended LO and RF Ports High Impedance DC Interface to Baseband Inputs with 0.5V Common Mode Voltage 16-Lead QFN 4mm × 4mm Package