5W AutoResonant Wireless Power Transmitter Features: Monolithic 5W Wireless Power Transmitter AutoResonant™ Switching Frequency Adjusts to Resonant Capacitance and Transmit Coil Inductance* Transmit Power Automatically Adjusts to Receiver Load* Input Voltage Range: 3V to 5.5V Integrated 100mΩ Full Bridge Switches Multiple Foreign Object Detection Methods Programmable Average Input Current Limit and Monitor NTC Input for System/Component Temperature Qualified Power Transfer Wide Operating Switching Frequency Range: 50kHz to 250kHz Thermally Enhanced 4mm × 5mm QFN 20-Lead Package

60V Dual Output Step-Down Controller with Digital Power System Management Features: PMBus/I2C Compliant Serial Interface Telemetry Read-Back Includes VIN, IIN, VOUT, IOUT, Temperature and Faults Programmable Voltage, Current Limit, Digital Soft-Start/Stop, Sequencing, Margining, OV/UV/OC, Frequency, and Control Loop Compensation Output Error Less Than ±0.5% Over Temperature Integrated 16-Bit ADC and 12-Bit DAC Integrated High Side Current Sense Amplifier Internal EEPROM with ECC and Fault Logging Integrated N-Channel MOSFET Gate DriversPower Conversion Wide VIN Range: 5V to 60V VOUT0, VOUT1 Range: 1V to 40V Analog Current Mode Control Accurate PolyPhase® Current Sharing for Up to 6 Phases (85kHz to 500kHz) Available in a 52-Lead (7mm× 8mm) QFN Package

2.5A Supercapacitor Backup Power Manager Features: 2.5A Step-Down Supercapacitor Charger and 2.5A Step-Up Backup Supply 6.5A Switches for 2.5A Backup from One Supercapacitor or Two in Series Input Current Limit Prioritizes Load over Charge Current Input Disconnect Switch Isolates Input During Backup Automatic Seamless Switch-Over to Backup Mode Internal Supercapacitor Balancer (No External Resistors) Programmable Charge Current and Charge Voltage Input Power Fail Indicator System Power Good Indicator Optional OVP Circuitry Protects Device to >60V Constant Frequency Operation Thermally Enhanced 24-Lead 4mm × 5mm QFN Package

25A, Dual PolyPhase Regulator with Digital Power System Management Features: PMBus/I2C Compliant Serial Interface Telemetry Read-Back Includes VIN, IIN, VOUT, IOUT, Temperature and Faults Programmable Voltage, Current Limit, Digital Soft-Start/Stop, Sequencing, Margining, OV/UV/OC Sub-Milliohm DCR Current Sensing Digitally Adjustable Loop Compensation Parameters 0.5% Output Voltage Accuracy Over Temperature Integrated Input Current Sense Amplifier Internal EEPROM with ECC and Fault Logging Integrated N-Channel MOSFET Gate Drivers

3GHz to 20GHz Microwave Mixer with Wideband DC to 6GHz IF Features:Integrated LO Buffer: 0dBm LO Drive50 Wideband Matched RF and LO PortsWide IF Bandwidth: DC to 6GHzUpconversion or DownconversionHigh IIP3:+22.5dBm at 10GHz+18.3dBm at 17GHz+14.6dBm Input P1dB at 10GHz8dB Conversion Loss at 10GHz3.3V/132mA SupplyFast Turn ON/OFF for TDD Operation3mm × 2mm, 12-Lead QFN Package

Very Low Noise, Low Distortion Active RC Quad Universal Filter Features: Continuous Time—No Clock Four 2nd Order Filter Sections, 20kHz to 300kHz Center Frequency Butterworth, Chebyshev, Elliptic or Equiripple Delay Response Lowpass, Bandpass, Highpass Responses 99dB Typical S/N, ±5V Supply (Q = 1) 93dB Typical S/N, Single 5V Supply (Q = 1) Rail-to-Rail Input and Output Voltages DC Accurate to 3mV (Typ) ±0.5% Typical Center Frequency Accuracy “Zero-Power” Shutdown Mode Single or Dual Supply, 5V to 10V Total Resistor-Programmable fO, Q, Gain

GaAs, pHEMT, MMIC, 1 W, Power Amplifier with Power Detector, 37 GHz to 40 GHz Features: 32 dBm typical saturated output power (PSAT) at 18% power added efficiency (PAE) at 39 GHz P1dB compression output power: 31.5 dBm typical High output third-order intercept (IP3): 40 dBm typical High gain: 24 dB typical 50 Ω matched input/output Ceramic, 6 mm × 6 mm, high frequency, air cavity package

26 GHz, T Flip-Flop w/Reset Features: Supports Clock Frequencies up to 26 GHz Differential & Singe-Ended Operation Fast Rise and Fall Times: 18/17 ps Low Power Consumption: 270 mW typ. Propagation Delay: 95 ps Single Supply: -3.3V 16 Lead Ceramic 3×3mm SMT Package: 9mm2

Wideband VCO SMT w/Buffer Amplifier SMT, 6 - 12 GHz Features: Wide Tuning Bandwidth Pout: +1 dBm Low SSB Phase Noise: -95 dBc/Hz @100 kHz No External Resonator Needed Single Positive Supply: +5V @ 57 mA 24 Lead 4x4mm SMT Package: 16mm2

9 GHz to 12 GHz, GaAs, MMIC, I/Q Downconverter Features: Conversion gain: 11 dB (typical) at IFOUT = 100 MHz Image rejection: 25 dB (typical) at IFOUT = 100 MHz LO to RF isolation: 46 dB (typical) LO to IF isolation: 26 dB (typical) IF output frequency: dc to 3.5 GHz 32-lead, 4.9 mm × 4.9 mm ceramic leadless chip carrier