Dual 5V, 2A Synchronous Step-Down DC/DCs in Tiny LQFN and WLCSP Features: Dual Outputs Each with 2A Output Current High Efficiency: 19mΩ NMOS and 75mΩ PMOS Wide Bandwidth, Fast Transient Response Switching Frequency Synchronizable Up to 3MHz VIN Range: 2.25V to 5.5V VOUT Range: 0.5V to VIN VOUT Accuracy: ±1% Low Ripple Burst Mode® Operation Peak Current Mode Control Minimum On-Time: 25ns Safely Tolerates Inductor Saturation in Overload Shutdown Current: 1.2µA Precision 400mV Enable Thresholds Internal Soft-Start and Compensation Power Good Output Low Profile, Thermally Enhanced 12-Lead 2mm × 2mm × 0.74mm LQFN and 16-Ball 1.64mm × 1.64mm × 0.5mm WLCSP Packages AEC-Q100 Qualified for Automotive Applications

40VIN, 1.2A Silent Switcher Module Regulator Features: Low Noise Silent Switcher® Architecture CISPR 22 Class B Compliance Wide Input Voltage Range: 3.2V to 40V Wide Output Voltage Range: 0.8V to 12V 1.2A Continuous Output Current at 24VIN, 5VOUT, TA = 85°C 1.75A Peak Output Current at 3.3VOUT Selectable Switching Frequency: 200kHz to 2.2MHz External Synchronization Configurable as an Inverter 4mm × 4mm × 1.82mm BGA Package

I2C Slave Device Extender Over Rugged Differential Link Features:Up to 1MHz Serial Clock, Fast-mode Plus (Fm+) Selectable Link Baud Rates Extend I2C Up to 1200m Protected from Overvoltage Line Faults to ±60V ±40kV ESD on Link Pins IEC Level 4 ESD ±8kV and EFT ±5kV on Link Pins Extended Common Mode Range: ±15V Remote Interrupt/SMBALERT and Control SignalsLow EMI Mode SMBus 3.0 Compatible I2C Idle Detection, and Stuck Bus Protection I2C Device Address Sharing 3V to 5.5V Supply Voltage 1.62V to 5.5V Logic Supply 4mm × 5mm 20-Lead QFN package

Low IQ , 60V, High Frequency Synchronous Step-Down Controller Features:Wide VIN Range: 4V to 60V (65V Abs Max)Low Operating IQ : 50μAWide Output Voltage Range: 0.8V ≤ VOUT ≤ 24VRSENSE or DCR Current SensingPhase-Lockable Frequency (320kHz to 2.25MHz)Programmable Fixed Frequency (320kHz to 2.25MHz)Selectable Continuous, Pulse-Skipping or Low RippleBurst Mode® Operation at Light LoadSelectable Current LimitVery Low Dropout Operation: 98% Duty CycleAdjustable Output Voltage Soft-Start or TrackingPower Good Output Voltage MonitorOutput Overvoltage ProtectionLow Shutdown IQ : < 14μAInternal LDO Powers Gate Drive from VIN or EXTVCCNo Current Foldback During Start-UpSmall 20-Pin 3mm × 4mm QFN Package

26V, 9A Low-IQ CC/CV Monolithic Buck-Boost Converter Features: Input Voltage Range: 2.5V to 26V 0.8V to 24V Output Voltage Range High Output Current 6.5A with VOUT = 5V, VIN > 6V 3A with VOUT = 5V, VIN = 3V 6.5A with VOUT = 12V, VIN > 14V 4 A with VOUT = 12V, VIN = 9V Ultralow Noise Buck-Boost Architecture Programmable Output Current Limit Programmable Frequency Range: 400kHz to 2MHz Accurate Enable Comparator Threshold Burst Mode® Operation, No-Load IQ = 35μA Current Mode Control External Clock Synchronization Maximum Power Point Control 28-Lead 4mm × 5mm LQFN Package

0.1 GHz to 6 GHz Silicon SP5T Switch Features: Nonreflective 50 Ω design Low insertion loss: 1.5 dB at 4 GHz High isolation: 50 dB at 4 GHz High input linearity 0.1 dB compression (P0.1dB): 34 dBm typical Third-order intercept (IP3): 57 dBm typical High power handling at 85°C 33 dBm through path 27 dBm terminated path ESD rating 3.5 kV HBM, Class 2 Single-supply or dual-supply operation Optional internal negative voltage generator (NVG) 1.8 V logic-compatible control 4 mm × 4 mm, 24-lead LFCSP

5.9 GHz to 23.6 GHz, Wideband, Microwave Upconverter Features: Wideband RF output frequency range: 5.9 GHz to 23.6 GHz Two upconversion modes Direct conversion from baseband I/Q to RF Single sideband upconversion from real IF LO input frequency range: 5.4 GHz to 14 GHz LO doubler for up to 28 GHz Matched 100 Ω balanced RF output, LO input, and IF input High impedance baseband inputs Sideband suppression and carrier feedthrough optimization Variable attenuator and power detector for Tx power control Programmable via 4-wire SPI interface 32-lead, 5 mm × 5 mm LFCSP microwave packaging

Integrated Dual RF Receiver Features: Dual receivers Maximum Receiver BW: 200 MHz Fully integrated, fractional-N, RF synthesizers Fully integrated clock synthesizer Multichip phase synchronization for RF LO and baseband clocks JESD204B datapath interface Tuneable range: 75 MHz to 6000 MHz

High Performance Fourth Generation DSP Features: 200 MHz core clock speed 2 Mbits of on-chip RAM FIR, IIR, and FFT accelerators Digital Applications Interface (DAI) enabling user-definable access to peripherals including an S/P DIF Tx/Rx, and 8-channel asynchronous sample rate converter Fully enhanced DMA engine including scatter/gather DMA, delay line DMA 8 serial ports (SPORTs) supporting I2S, left-justified sample pair, and TDM modes Watch Dog Timer Shift Registers 2 SPI-compatible ports supporting master and slave modes UART and Two-Wire Interface 16 Pulse Width Modulation (PWM) channels 3 full-featured timers Small footprint, 88-lead LFCSP and 100-Ld LQFP package options Commercial, Industrial, and automotive temperature ranges available

Up to 1GHz SHARC+ DSP with 640KB L1, 1024KB Shared L2 SRAM, 400-Ball CSP_BGA Features:SHARC+ Core infrastructure 800MHz (max) or 1GHz (max) Core clock frequency 640KB on-chip Level 1 (L1) SRAM memory (with parity) increases low latency performance 32-bit, 40-bit & 64-bit floating point support 32-bit fixed point Byte, short-word, word, long-word addressedMemory 1024KB on-chip Level 2 (L2) SRAM with ECC protection - eliminates need for external memory in many use cases One Level 3 (L3) interface optimized for low system power, providing 16-bit interface to DDR3 (supporting 1.35 V capable DDR3L devices) SDRAM devices16-bit DDR/DDR3L Memory Controller 1.35V support for DDR3LAdvanced Hardware Accelerators Enhanced FIR/IIR offload engines running at Core clock frequency for added processing power Security Crypto Engines with OTPPowerful DMA SystemInnovative Digital Audio Interface (DAI) includes: 8x Full SPORT interfaces w/TDM & I2S modes 2x S/PDIF Rx/Tx, 8 ASRC pairs 4x Precision Clock Generators 28 BuffersOther Peripheral Connectivity / Interfaces: 2x Quad SPI, 1x Octal SPI MLB 3-pin 6x I2C,3x UARTs 2x Link Ports 10x General Purpose Timer, 1x General Purpose Counter 2x Watchdog Timers 4-ch 12bit Housekeeping ADCs 40 GPIO pins, 28 DAI pins Thermal SensorPackage 17mm x 17mm (0.8mm pitch) 400-ball CSP_BGAAdditional Features Security and Protection Crypto hardware accelerators Fast secure boot with IP protection Enhanced FIR and IIR accelerators running up to 1 GHz AEC-Q100 qualified for automotive applications