55V Buck-Boost Multi-Chemistry Battery Charger Features: Wide Voltage Range: 4.5V to 55V Input, Up to 55V Output (60V Absolute Maximums) Synchronous Buck-Boost DC/DC Controller Li-Ion and Lead-Acid Charge Algorithms ±0.5% Float Voltage Accuracy ±5% Charge Current Accuracy Instant-On for Heavily Discharged Batteries Ideal Diode Controller Provides Low Loss PowerPath When Input Power is Limited Input Voltage Regulation for High Impedance Input Supplies and Solar Panel Peak Power Operation Onboard Timer for Protection and Termination Bad Battery Detection with Auto-Reset NTC Input for Temperature Qualified Charging Binary Coded Open-Collector Status Pins Low Profile (0.75mm) 38-Pin 5mm × 7mm QFN Package

Dual 42V Synchronous Monolithic Step-Down Regulator with 6.5A Quiescent Current Features: Wide Input Voltage Range: 3.4V to 42V 2.5A and 1.5A Buck Regulators with Separate Inputs Fast Minimum Switch On-Time: 35ns Ultralow Quiescent Current Burst Mode® Operation: 6.5μA IQ Regulating 12VIN to 5VOUT and 3.3VOUT Output Ripple < 15mV 180° Out of Phase Switching Adjustable: 200kHz to 3MHz Synchronizable: 250kHz to 3MHz Accurate 1V Enable Pin Thresholds Internal Compensation Output Soft-Start and Tracking TSSOP Package: Output Stays at or Below Regulation Voltage During Adjacent Pin Short or When a Pin Is Left Floating Thermally Enhanced 28-Lead TSSOP and 3mm × 6mm QFN Packages

Dual Output PolyPhase Step-Down DC/DC Voltage Mode Controller with Digital Power System Management Features: PMBus/I2C Compliant Serial Interface Monitor Voltage, Current, Temperature and Faults Digitally Programmable Voltage, Current Limit, Soft-Start/Stop, Sequencing, Margining, AVP and UV/OV Thresholds 3V ≤ VINSNS ≤ 38V, 0.5V ≤ VOUT ≤ 5.25V ±0.5% Output Voltage Accuracy Programmable PWM Frequency or External Clock Synchronization from 250kHz to 1.25MHz Accurate PolyPhase® Current Sharing Internal EEPROM with Fault Logging and ECC IC Supply Range: 3V to 13.2V Resistor or Inductor DCR Current Sensing Optional Resistor Programming for Key Parameters 40-Pin (6mm × 6mm) QFN Package AEC-Q100 Qualified for Automotive Applications

Boost/SEPIC/Inverting DC/DC Converter with 1A, 65V Switch, Soft-Start and Synchronization Features: 1A, 65V Power Switch Adjustable Switching Frequency Single Feedback Resistor Sets VOUT Synchronizable to External Clock High Gain SHDN Pin Accepts Slowly Varying Input Signals Wide Input Voltage Range: 2.55V to 40V Low VCESAT Switch: 400mV at 0.75A (Typical) Integrated Soft-Start Function Easily Configurable as a Boost, SEPIC, or Inverting Converter User Configurable Undervoltage Lockout (UVLO) Pin Compatible with LT3580 Tiny Thermally Enhanced 8-Lead 3mm × 3mm DFN and 8-Lead MSOP Packages AEC-Q100 Qualified for Automotive Applications

60V Low IQ, Dual, 2-Phase Synchronous Step-Down DC/DC Controller Features: Wide VIN Range: 4.5V to 60V (65V Abs Max) Wide Output Voltage Range: 0.8V ≤ VOUT ≤ 99% • VIN Adjustable Gate Drive Level 5V to 10V (OPTI-DRIVE) No External Bootstrap Diodes Required Low Operating IQ: 29μA (One Channel On) Selectable Gate Drive UVLO Thresholds Out-of-Phase Operation Reduces Required Input Capacitance and Power Supply Induced Noise Phase-Lockable Frequency: 75kHz to 850kHz Selectable Continuous, Pulse Skipping or Low Ripple Burst Mode® Operation at Light Loads Selectable Current Limit (LTC3892/LTC3892-2) Very Low Dropout Operation: 99% Duty Cycle Power Good Output Voltage Monitors (LTC3892/LTC3892-2) Low Shutdown IQ: 3.6μA Small 32-Lead 5mm × 5mm QFN Package (LTC3892/LTC3892-2) or TSSOP Package (LTC3892-1)

High Efficiency, Secondary-Side Synchronous Forward Controller Features: Direct Flux Limit™ Guarantees No Saturation Fast and Accurate Average Current Limit Clean Start-Up Into Pre-Biased Output Secondary-Side Control for Fast Transient Response Simple, Self-Starting Architecture Synchronous MOSFET Reverse Current Limit PolyPhase® Operation Eases High-Power Design True Remote Sense Differential Amplifier Remote Sense Reverse Protection High Voltage Linear Regulator Controller Internal LDO Powers Gate Drive from VOUT Overtemperature/Overvoltage Protection Low Profile 4mm × 5mm QFN and Narrow 28-Lead SSOP Packages

40A DC/DC Module Regulator Features: Stacked Inductor Acts as Heat Sink Wide Input Voltage Range: 4.7V to 15V 0.6V to 3.3V Output Voltage Range ±1.3% Total DC Output Voltage Error Over Line, Load and Temperature (–40°C to 125°C) Differential Remote Sense Amplifier for Precision Regulation Current Mode Control/Fast Transient Response Frequency Synchronization Parallel Current Sharing (Up to 240A) Internal or External Compensation 88% Efficiency (12VIN, 1VOUT) at 40A Overcurrent Foldback Protection 16mm × 16mm × 7.07mm BGA Package

40A Module Regulator with Overvoltage/ Overtemperature Protection Features:Overtemperature, Input/Output Overvoltage ProtectionTrips Upstream Power Source or Circuit BreakerStacked Inductor Acts as Heat SinkWide Input Voltage Range: 4.7V to 15V0.6V to 3.3V Output Voltage Range±1.3% Total DC Output Voltage Error (–40°C to 125°C)Differential Remote Sense Amplifier for Precision RegulationCurrent Mode Control/Fast Transient ResponseFrequency SynchronizationParallel Current Sharing (Up to 240A)88% Efficiency (12VIN, 1VOUT) at 40AOvercurrent Foldback ProtectionOvertemperature Shutdown16mm × 16mm × 7.07mm BGA Package

36V, 2A Synchronous Step-Up LED Driver Features:±2.5% LED Current Regulation±2% Output Voltage Regulation5000:1 PWM Dimming at 100Hz128:1 Internal PWM DimmingSpread-Spectrum Frequency ModulationSilent Switcher® Architecture for Low EMIOperates in Boost, Buck Mode and Buck-Boost Mode2.8V to 36V Input Voltage RangeUp to 34V LED String Voltage2A, 40V Internal Switches200kHz to 2MHz with SYNC FunctionAnalog or Duty Cycle LED Current ControlOpen/Short LED Protection and Fault IndicationThermally Enhanced 28-Pin (4mm × 5mm) QFN

Dual Output PolyPhase Step-Down DC/DC Voltage Mode Controller with Digital Power System Management Features: PMBus/I2C Compliant Serial Interface Monitor Voltage, Current, Temperature and Faults Digitally Programmable Voltage, Current Limit, Soft-Start/Stop, Sequencing, Margining, AVP and UV/OV Thresholds 3V ≤ VINSNS ≤ 38V, 0.5V ≤ VOUT ≤ 5.25V ±0.5% Output Voltage Accuracy Programmable PWM Frequency or External Clock Synchronization from 250kHz to 1.25MHz Accurate PolyPhase® Current Sharing Internal EEPROM with Fault Logging and ECC IC Supply Range: 3V to 13.2V Resistor or Inductor DCR Current Sensing Optional Resistor Programming for Key Parameters 40-Pin (6mm × 6mm) QFN Package AEC-Q100 Qualified for Automotive Applications