High Efficiency, 2-Phase Synchronous Step-Down Switching Regulator Features: 180° Phased Dual Controllers Reduce Required Input Capacitance and Power Supply Induced Noise OPTI-LOOP® Compensation Minimizes COUT ±1.5% Output Voltage Accuracy over Temperature Dual N-Channel MOSFET Synchronous Drive Power Good Output Voltage Monitor DC Programmed Fixed Frequency 150kHz to 300kHz Wide VIN Range: 4.5V to 28V Operation Very Low Dropout Operation: 99% Duty Cycle Adjustable Soft-Start Current Ramping Foldback Output Current Limiting Latched Short-Circuit Shutdown with Defeat Option Output Overvoltage Protection Remote Output Voltage Sense Low Shutdown IQ : 20µA 5V and 3.3V Standby Regulators Selectable Constant Frequency, Burst Mode® Operation or PWM Operation Small 28-Lead Narrow SSOP Package

1kHz-3GHz High Signal Level Active Mixer Features: Broadband RF, LO and IF Operation High Input IP3: >20dBm from 30MHz to 900MHz +17dBm at 1900MHz Typical Conversion Gain: 1dB SSB Noise Figure: 11dB at 900MHz 14dB at 1900MHz Integrated LO Buffer: Insensitive to LO Drive Level Single-Ended or Differential LO Drive High LO-RF Isolation Enable Function 4.5V to 5.25V Supply Voltage Range 4mm x 4mm QFN Package

Dual Smart Battery System Manager Features: SMBus Charger/Selector for Two Smart Batteries* Voltage and Current Accuracy within 0.2% of Value Reported by Battery Simplifies Construction of “Smart Battery System Manager” Includes All SMBus Charger V1.1 Safety Features Supports Autonomous Operation without a Host Allows Both Batteries to Discharge Simultaneously into Single Load with Low Loss (Ideal Diode) SMBus Switching for Dual Batteries with Alarm Monitoring for Charging Battery at All Times Pin Programmable Limits for Maximum Charge Current and Voltage Improve Safety Fast Autonomous Power Path™ Switching (<10µs) Low Loss Simultaneous Charging of Two Batteries >95% Efficient Synchronous Buck Charger AC Adapter Current Limiting* Maximizes Charge Rate SMBus Accelerator Improves SMBus Timing** Available in 48-Lead TSSOP Package

1.5MHz, 600mA Synchronous Step-Down Regulator in ThinSOT Features: High Efficiency: Up to 96% Very Low Quiescent Current: Only 20µA During Operation 600mA Output Current 2.5V to 5.5V Input Voltage Range 1.5MHz Constant Frequency Operation No Schottky Diode Required Low Dropout Operation: 100% Duty Cycle 0.6V Reference Allows Low Output Voltages Shutdown Mode Draws </=1µA Supply Current Current Mode Operation for Excellent Line and Load Transient Response Overtemperature Protected Low Profile (1mm) ThinSOT™ Package

1.5MHz, 600mA Synchronous Step-Down Regulator in ThinSOT Features: High Efficiency: Up to 96% Very Low Quiescent Current: Only 20µA During Operation 600mA Output Current 2.5V to 5.5V Input Voltage Range 1.5MHz Constant Frequency Operation No Schottky Diode Required Low Dropout Operation: 100% Duty Cycle 0.6V Reference Allows Low Output Voltages Shutdown Mode Draws ≤1µA Supply Current Current Mode Operation for Excellent Line and Load Transient Response Overtemperature Protected Low Profile (1mm) ThinSOT™ Package

250kHz Low Supply Current High Efficiency 1.5A Switching Regulator Features: 1mA IQ at 250kHz Uses Small Inductors: 15µH All Surface Mount Components Only 0.6 Square Inch of Board Space Low Minimum Supply Voltage: 2.7V Constant Frequency Current Mode Current Limited Power Switch: 1.5A Regulates Positive or Negative Outputs Shutdown Supply Current: 12µA Typ Easy External Synchronization 8-Pin SO or PDIP Packages

Triple Output Power Supply for Small TFT-LCD Displays Features: Generates Three Voltages: 5.1V at 10mA 5V, -10V, or -15V at 500µA 10V or 15V at 500µA Better than 90% Efficiency Low Output Ripple: Less than 5mVP-P Complete 1mm Component Profile Solution Controlled Power-Up Sequence: AVDD/VGL/VGH All Outputs Disconnected and Actively Discharged in Shutdown Low Noise Fixed Frequency Operation Frequency Reduction Input for High Efficiency in Blank Mode Ultralow Quiescent Current: 75µA (Typ) in Scan Mode Available in a 3mm × 3mm 16-Pin QFN Package

3-Phase, 600kHz, Synchronous Buck Switching Regulator Controller Features: 3-Phase Current Mode Controller with Onboard MOSFET Drivers ±5% Output Current Matching Optimizes Thermal Performance and Size of Inductors and MOSFETs Differential Amplifier Accurately Senses VOUT ±1% VREF Accuracy Over Temperature VOUT Range: 0.6V to 5.5V without Diffamp VOUT Range: 0.6V to (VCC – 1.2V) with Diffamp 250kHz to 600kHz Per Phase, PLL, Fixed Frequency PWM, Stage Shedding™ or Burst Mode® Operation OPTI-LOOP® Compensation Minimizes COUT Adjustable Soft-Start Current Ramping Short-Circuit Shutdown Timer with Defeat Option Overvoltage Soft Latch Adjustable Undervoltage Lockout Threshold Selectable Phase Output for Up to 12-Phase Operation Available in 5mm × 5mm QFN and 36-Pin Narrow (0.209') SSOP Packages

Single/Dual Power Supply Margining Controller Features: Margin Voltage Precision <0.4% 400:1 Current Programming Range Symmetric/Asymmetric High and Low Voltage Margining Single Control Pin per Supply-High, Float, Low Single Current Setting Resistor per Supply Wide VCC Compliance 2.3V < VCC < 6V Wide Output Compliance 0.6V < VMARGIN < (VCC - 0.6V) Single in 5-Pin ThinSOT™ (LTC2920-1) Dual in 8-Pin MSOP (LTC2920-2)

Digitally Controlled Programmable Gain Amplifiers in SOT-23 Features: 3-Bit Digital Gain Control in Three Gain-Code Options Rail-to-Rail Input Range Rail-to-Rail Output Swing Single or Dual Supply: 2.7V to 10.5V Total 11MHz Gain Bandwidth Product Input Noise Down to 8nV/√Hz System Dynamic Range to 120dB Input Offset Voltage: 1.5mV 8-Pin Low Profile (1mm) SOT-23 (ThinSOT™) Package