The MAX3643 burst-mode laser driver provides bias and modulation current drive for PON burst-mode ONT applications. It is specifically designed for use with a low-cost external controller for the APC (and if desired, AMC) loop. A high-speed differential burst-enable input enables the driver to switch the laser from a dark (output off) condition to full on condition in less than 2ns.When BEN is inactive, typical modulation and bias currents are 5µA each.Laser modulation current can be set from 10mA to 85mA and bias current can be set from 1mA to 70mA using the MODSET and BIASSET inputs. A sample-and-hold circuit is provided to capture the monitor diode output during short PON bursts, if needed, and the BEN high-speed signal is mirrored on an LVCMOS output to be used by the controller operating the APC/AMC loop.The MAX3643 burst-mode laser driver is packaged in a 4mm x 4mm, 24-pin thin QFN package. It operates from -40°C to +85°C.Applications1.25Gbps IEEE EPON ONT ModulesA/B/G/XGPON ONT Modules Up to 2.5Gbps

Laser Drivers 622Mbps LAN/WAN

Laser Drivers 3.3V 0.155-2.5Gbps DC coupled LDD

LASER DIODE;

ONET4211LD 155-Mbps to 4.25-Gbps laser driver

ONET4201LD 155-Mbps to 4.25-Gbps laser driver with active back termination

ONET1141L 11.3-Gbps modulator driver

Clock and Data Recovery IC 32-Pin QFN

Laser Drivers 3.2Gbps Low-Power SFP Laser Driver

MAX3656 155 Mega Bits Per Sec To 2.5 Giga Bits Per Sec Burst-Mode Laser Driver