Single Switch Synchronous Forward Controller Features: Synchronous Rectifier Control for High Efficiency Programmable Volt-Second Clamp Output Power Levels from 25W to 500W Low Current Start-Up (LT1952: 460µA; VIN On/Off = 14.25V/8.75V) (LT1952-1: 400µA; VIN On/Off = 7.75V/6.5V) True PWM Soft-Start Low Stress Short Circuit Protection Precision 107mV Current Limit Threshold Adjustable Delay for Synchronous Timing Accurate Shutdown Threshold with Programmable Hysteresis Programmable Slope Compensation Programmable Leading Edge Blanking Programmable Frequency (100kHz to 500kHz) Synchronizable to an External Clock up to 1.5 • fOSC Internal 1.23V Reference 2.5V External Reference Current Mode Control Small 16-Pin SSOP Package

37V/1.2A Step-Down Regulator in 3mm 3mm DFN Features: Wide Input Range: Operation from 3.6V to 37V Overvoltage Lockout Protects Circuit Through 55V Transients Low Minimum On-Time: Converts 16VIN to 3.3VOUT at 2MHz 1.2A Output Current Adjustable Frequency: 300kHz to 2.5MHz Constant Switching Frequency at Light Loads Tracking and Soft-Start Precision UVLO Short-Circuit Robust IQ in Shutdown <1μA Internally Compensated 10-Lead 3mm × 3mm DFN Package

12 Channel Multicell Battery Monitor with Daisy Chain Interface, Generation 1 Features: Qualified for Automotive Applications Measures Up to 12 Li-Ion Cells in Series (60V Max) Stackable Architecture Enables >1000V Systems 0.25% Maximum Total Measurement Error 13ms to Measure All Cells in a System Cell Balancing: On-Chip Passive Cell Balancing Switches Provision for Off-Chip Passive Balancing Two Thermistor Inputs Plus On-Board Temperature Sensor 1MHz Daisy-Chainable Serial Interface High EMI Immunity Delta Sigma Converter with Built-In Noise Filter Open Wire Connection Fault Detection Low Power Modes 44-Lead SSOP Package

Single 12-/10-/8-Bit I2C VOUT DACs with 10ppm/C Reference Features: Integrated Precision Reference 2.5V Full-Scale 10ppm/°C (LTC2631-L) 4.096V Full-Scale 10ppm/°C (LTC2631-H) Maximum INL Error: 1LSB (LTC2631A-12) Bidirectional Reference: Input or 10ppm/°C Output 400kHz I2C Interface Nine Selectable Addresses (LTC2631-Z) Low Noise (0.7mVP-P , 0.1Hz to 200kHz) Guaranteed Monotonic Over Temperature 2.7V to 5.5V Supply Range (LTC2631-L) Low Power Operation: 180μA at 3V Power Down to 1.8μA Maximum (C and I Grades) Power-On Reset to Zero or Mid-Scale Options Double-Buffered Data Latches Guaranteed Operation From –40°C to 125°C (H-Grade) 8-Lead TSOT-23 (ThinSOT™) Package

50 V, 130 kHz, 32.5 A, Robust, Over-The-Top Precision Op Amp Features: Ultrawide common-mode input range: −VS − 0.1 V to −VS + 70 V Wide power supply voltage range: +3 V to +50 V (to ±25 V for PSRR) Low power supply current: 32.5 μA (typical) Low input offset voltage: ±60 μV maximum Low input offset voltage drift: ±1 μV/°C maximum (B grade) Low input voltage noise 6 Hz typical 1/f noise corner 1000 nV p-p typical at 0.1 Hz to 10 Hz GBP: 130 kHz typical for fTEST = 250 Hz Slew rate: 0.1 V/μs typical at ΔVOUT = 4 V Low power supply current shutdown: 20 μA maximum Low input offset current: ±300 pA maximum Large signal voltage gain: 120 dB minimum for ΔVOUT = 3.5 V CMRR: 120 dB minimum at VCM = −0.1 V to +70 V PSRR: 123 dB minimum at VSY = +3 V to ±25 V Input overdrive tolerant with no phase reversal ±2 kV HBM and ±1.25 kV FICDM Wide temperature range: −55°C to +150°C (H grade) Shutdown feature available for single 6-lead TSOT and dual 10-lead LFCSP packages

50 V, 130 kHz, 32.5 A per Channel, Robust, Over-The-Top, Precision Op Amp Features: Ultrawide common-mode input range: −VS − 0.1 V to −VS + 70 V Wide power supply voltage range: +3 V to +50 V (to ±25 V for PSRR) Low power supply current: 32.5 μA (typical) Low input offset voltage: ±60 μV maximum Low input offset voltage drift: ±1 μV/°C maximum (B grade) Low input voltage noise 6 Hz typical 1/f noise corner 1000 nV p-p typical at 0.1 Hz to 10 Hz GBP: 130 kHz typical for fTEST = 250 Hz Slew rate: 0.1 V/μs typical at ΔVOUT = 4 V Low power supply current shutdown: 20 μA maximum Low input offset current: ±300 pA maximum Large signal voltage gain: 120 dB minimum for ΔVOUT = 3.5 V CMRR: 120 dB minimum at VCM = −0.1 V to +70 V PSRR: 123 dB minimum at VSY = +3 V to ±25 V Input overdrive tolerant with no phase reversal ±2 kV HBM and ±1.25 kV FICDM Wide temperature range: −55°C to +150°C (H grade) Shutdown feature available for single 6-lead TSOT and dual 10-lead LFCSP packages

50 V, 130 kHz, 32.5 A per Channel, Robust, Over-The-Top, Precision Op Amp Features: Ultrawide common-mode input range: −VS − 0.1 V to −VS + 70 V Wide power supply voltage range: +3 V to +50 V (to ±25 V for PSRR) Low power supply current: 32.5 μA (typical) Low input offset voltage: ±60 μV maximum Low input offset voltage drift: ±1 μV/°C maximum (B grade) Low input voltage noise 6 Hz typical 1/f noise corner 1000 nV p-p typical at 0.1 Hz to 10 Hz GBP: 130 kHz typical for fTEST = 250 Hz Slew rate: 0.1 V/μs typical at ΔVOUT = 4 V Low power supply current shutdown: 20 μA maximum Low input offset current: ±300 pA maximum Large signal voltage gain: 120 dB minimum for ΔVOUT = 3.5 V CMRR: 120 dB minimum at VCM = −0.1 V to +70 V PSRR: 123 dB minimum at VSY = +3 V to ±25 V Input overdrive tolerant with no phase reversal ±2 kV HBM and ±1.25 kV FICDM Wide temperature range: −55°C to +150°C (H grade) Shutdown feature available for single 6-lead TSOT and dual 10-lead LFCSP packages

50 V, 8 MHz, 1.5 mA per Channel, Robust, Over-The-Top, Precision Op Amps Features: Ultrawide common-mode range: −VS − 0.1 V to −VS + 70 V Wide power supply voltage range: (VSY): +3.15 V to +50 V (±25 V for PSRR) Low supply current: 1.5 mA per channel (typical) Low input offset voltage: ±40 μV maximum Low input offset voltage drift: ±0.4 μV/°C maximum Low voltage noise: 1/f noise corner: 6 Hz typical 150 nV p-p typical at 0.1 Hz to 10 Hz 7 nV/√Hz typical at 100 Hz (en) High speed GBP: 8 MHz typical Slew rate: 5.5 V/μs typical at ΔVOUT = 25 V Low power shutdown: 20 μA maximum Low input bias current: ±10 nA maximum Large signal voltage gain: 120 dB minimum CMRR: 118 dB, minimum PSRR: 123 dB, minimum Input overdrive tolerant with no phase reversal ±2 kV HBM and ±1.25 kV FICDM Wide temperature range: −55°C to +150°C (H grade)

OVP and EMI Protected, Precision, Low Noise and Bias Current Single Op Amp Features: Low offset voltage: 60 μV maximum at 25°C (8-lead and 14-lead SOIC) Low offset voltage drift: 1 μV/°C maximum (8-lead and 14-lead SOIC) Low input bias current: 1 nA maximum at 25°C Low voltage noise density: 8 nV/√Hz typical at 1 kHz Large signal voltage gain (AVO): 100 dB minimum over full supply voltage and operating temperature Input overvoltage protection to 32 V above and below the supply voltage rail Integrated EMI filter 70 dB typical rejection at 1000 MHz 90 dB typical rejection at 2400 MHz Rail-to-rail output swing Low supply current: 500 μA typical per amplifier Wide bandwidth Gain bandwidth product (AV = 100): 3.5 MHz typical Unity-gain crossover (AV = 1): 3.5 MHz typical −3 dB bandwidth (AV = 1): 6 MHz typical Dual-supply operation Specified at ±5 V to ±15 V, operates over ±2.5 V to ±18 V Unity-gain stable No phase reversal Long-term offset voltage drift (10,000 hours): 2 μV typical Temperature hysteresis: 2 μV typical

Bridge Sensor Signal Conditioner IC with LIN Interface, Nonlinearity Correction, Temperature Compensation Features:LIN 2.1 compliant interface (bridge sensor signal, temperature)Digitally programmable gain and offset voltage adjustmentGain range from 2.94 V/V to 971.10 V/VSensor temperature compensation (first- or second-order)Sensor nonlinearity correction (first- or second-order)Internal or external temperature sensor compensationEEPROM nonvolatile memory for calibration dataHigh system accuracy: 0.1% FSR over temperatureEMC and EMI protectionFault protection for open circuits and short circuits4 mm 4 mm, 20-lead LFCSP6 V to 18 V supply operation40C to +150C operating temperature rangeAEC-Q100 qualified for automotive applications