+5 Volt, Serial Input, Dual 12-Bit DAC Features: Complete Dual 12-Bit DAC No External Components +5 Single-Supply Operation ±10% 4.095 V Full Scale (1 mV/LSB) Buffered Voltage Outputs Low Power: 5 mW/DAC Space Saving 1.5mm Height SO-14 Package

Digitally Programmable Sensor Signal Amplifier with EMI Filters Features: EMI filters at input pins Specified from −40°C to +140°C Low offset voltage: 10 μV maximum Low input offset voltage drift: 65 nV/°C maximum High CMRR: 94 dB minimum Digitally programmable gain and output offset voltage Programmable output clamp voltage Open and short wire fault detection Low-pass filtering Single-wire serial interface Stable with any capacitive load SOIC_N and LFCSP_VQ packages 4.5 V to 5.5 V operation

Ultrafast 7 ns Single Supply Comparator Features: 7 ns propagation delay at 5 V Single supply operation: 3 V to 10 V Low power Latch function TSSOP packages

40V, 7A Ideal Diode Features: Reduces Power Dissipation by Replacing a Power Schottky Diode with No External Components Internal 7A, 21mΩ N-Channel MOSFET 15mV Regulated Forward Voltage 20μA Operating Current, 0.8μA Shutdown Wide 0V to 40V Input Range with VCC > 2.75V Fast Turn-On Minimizes Voltage Droop Fast Reverse Recovery Time Minimizes Reverse Transient Current Smooth Switchover in Diode-OR Applications 16-Lead 2mm × 3mm LQFN Package

Ultrathin Low VIN, 2A Buck-Boost Module Regulator Features: Wide Input Voltage Range: 2.6V to 5.5V Adjustable Output Voltage Range: 1.8V to 5.5V 2A of Continuous Output Current with VIN ≥ VOUT (Buck Mode and Buck-Boost Mode); Minimum 1A Continuous Output Current with VIN < VOUT (Boost Mode). Low Ripple Buck-Boost Architecture Programmable Soft-Start and VIN UVLO Burst Mode IQ 15μA for High Efficiency at Light Loads Ultrathin, Small Surface Mount Footprint 3.5mm × 4mm × 1.25mm LGA Package

42V, 5A/7A Peak Synchronous Step-Down Silent Switcher with 2.5A Quiescent Current Features: Silent Switcher® Architecture Ultralow EMI Emissions Optional Spread Spectrum Modulation High Efficiency at High Frequency Up to 96% Efficiency at 1MHz, 12VIN to 5VOUT Up to 95% Efficiency at 2MHz, 12VIN to 5VOUT Wide Input Voltage Range: 3.4V to 42V 5A Maximum Continuous, 7A Peak Transient Output Ultralow Quiescent Current Burst Mode® Operation 2.5µA IQ Regulating 12VIN to 3.3VOUT Output Ripple < 10mVP-P Fast Minimum Switch On-Time: 30ns Low Dropout Under All Conditions: 100mV at 1A Forced Continuous Mode Adjustable and Synchronizable: 200kHz to 3MHz Output Soft-Start and Power Good Small 20-Lead 4mm × 3mm LQFN Package AEC-Q100 Qualified for Automotive Applications

36V 10W No-Opto Isolated Flyback Converter Features: 4V to 36V Input Voltage Range 3.6A, 65V Internal DMOS Power Switch Low Quiescent Current Quasi-Resonant Boundary Mode Operation at Heavy Load Low Ripple Burst Mode® Operation at Light Load Minimum Load < 0.5% (Typ) of Full Output No Transformer Third Winding or Opto-Isolator Required for Output Voltage Regulation Accurate EN/UVLO Threshold and Hysteresis Temperature Compensation for Output Diode Output Short-Circuit Protection Thermally Enhanced 8-Lead SO Package

Micropower, Regulated Charge Pump DC/DC Converters Features: 5V Output Current: 100mA (VIN ≥ 3V) 3.3V Output Current: 80mA (VIN ≥ 2.5V) Ultralow Power: 20µA Quiescent Current Regulated Output Voltage: 3.3V ±4%, 5V ±4%, ADJ VIN Range: 2V to 5.5V 800kHz Switching Frequency No Inductors Very Low Shutdown Current: <2µA Shutdown Disconnects Load from VIN PowerGood/Undervoltage Output Adjustable Soft-Start Time Short-Circuit/Thermal Protection Available in 8-Pin MSOP

20-Bit Power No Latency ADC in SO-8 Features: 20-Bit ADC in SO-8 Package 8ppm INL, No Missing Codes at 20 Bits 4ppm Full-Scale Error 0.5ppm Offset 1.2ppm Noise Digital Filter Settles in a Single Cycle. Each Conversion Is Accurate, Even After an Input Step Fast Mode: 16-Bit Noise, 12 Bits TUE at 100sps Internal Oscillator—No External Components Required 110dB Min, 50Hz/60Hz Notch Filter Reference Input Voltage: 0.1V to VCC Live Zero—Extended Input Range Accommodates 12.5% Overrange and Underrange Single Supply 2.7V to 5.5V Operation Low Supply Current (200µA) and Auto Shutdown Pin Compatible with 24-Bit LTC2400

Lithium-Ion Battery Pulse Chargers with Overcurrent Protection Features: Complete Pulse Charger for 1-Cell Lithium-Ion Batteries Sense Resistor Limits Maximum Current for Safety 1% Float Voltage Accuracy End-of-Charge (C/10) Detection Output Programmable Charge Termination Timer Internal 0.35 NMOS Switch No Blocking Diode Required SEL Pin to Set Either 4.1V or 4.2V/Cell (LTC1730-4) Low-Battery Drain (1µA Max) when Input Supply Is Removed Battery Temperature Sensing and Charge Qualification Automatic Trickle Charge for Low-Battery Cell Automatic Battery Refresh