Dual-Channel Isolators with Integrated DC-to-DC Converter (1/1 channel directionality) Features: isoPower® integrated isolated DC/DC converter Regulated 3V or 5V output Up to 500 mW output power 16-lead SOIC package with 7.6 mm creepage Dual dc-to-25 Mbps (NRZ) signal isolation channels High temperature operation: 105°C maximum High common-mode transient immunity: > 25 kV/µsSafety and regulatory approvals UL recognition 2500 V rms for 1 minute per UL 1577 VDE cert of conformity (pending) IEC 60747-5-2 (VDE V 0884-10):2006-12 VIORM = 560 VPEAK See data sheet for additional features

Low Emission, 5 kV Isolated DC-to-DC Converters Features: isoPower integrated, isolated dc-to-dc converter 100 mA output current for ADuM6020 AEC-Q100 qualified for automotive applications Meets CISPR22 Class B emissions limits at full load on a 2layer PCB 16-lead SOIC_IC package with 8.3 mm minimum creepage High temperature operation: 125°C maximum Safety and regulatory approvals UL recognition 5000 V rms for 1 minute per UL 1577 CSA Component Acceptance Notice 5A VDE certificate of conformity VDE V 0884-10 VIORM = 565 V peak CQC certification per GB4943.1-2011

Quad-Channel Isolators with Integrated DC-to-DC Converter (3:1 directionality) Features: isoPower integrated, isolated dc-to-dc converter 100 mA output supply AEC-Q100 qualified for automotive applications ADuM6421AW (ADuM6423AW pending) Meets CISPR 32/EN55032 Class B emission limits up to 5 Mbps at a full load on a 2-layer PCB Quad dc to 100 Mbps signal isolation channels 28-lead, fine pitch, SOIC with 8.3 mm minimum creepage High temperature operation: 125°C maximum High common-mode transient immunity: 100 kV/μs Safety and regulatory approvals (pending) UL recognition (pending) 5000 V rms for 1 minute per UL 1577 CSA Component Acceptance Notice 5A (pending) VDE V 0884-11 certificate of conformity (pending) VIORM = 566 V peak CQC certification per GB4943.1-2011 (pending)

Isolated High Accuracy Digital Temperature Measurement System with EEPROM Features:5000VRMS Isolated Power and SPI InterfaceDirectly Digitizes 2-, 3- or 4-Wire RTDs, Thermocouples, Thermistors and Diodes10 Flexible Inputs Allow Interchanging SensorsAutomatic Thermocouple Cold Junction CompensationBuilt-In Standard and User-Programmable Coefficients for Thermocouples, RTDs and ThermistorsAutomatic Burn Out, Short-Circuit and Fault DetectionBuffered Inputs Allow External ProtectionSimultaneous 50Hz/60Hz RejectionIncludes 15ppm/°C (Max) ReferenceIncludes Special Protection ModesOn-Chip EEPROM Stores Channel Configuration Data and Custom Coefficients

Ultrathin 1.5A Module Thermoelectric Cooler (TEC) Regulator Features:Built-in Two Zero-Drift, Rail-to-Rail Chopper Amplifiers2.7V to 5.5V Input Voltage Range1.5A Driving Capability1% Accuracy 2.5V Internal Reference OutputIndependent Programmable Heating and Cooling Current LimitTEC Voltage and Current MonitoringProgrammable Maximum TEC VoltageDefault 2MHz Switching FrequencySynchronization from 1.85MHz to 3.25MHzCapable of NTC, PTC and RTD Thermal Sensors3.5mm 4mm 1.3mm LGA Package

High Voltage High Current Hot Swap Controller Features: Allows Safe Board Insertion into Live Backplane Wide Operating Voltage Range: 6.5V to 80V Drives Two Gates for High Power Applications Configurable Parallel, Staged Start or Single MOSFET Modes Adjustable Precision Current Limit: 6mV to 20mV Current Foldback Limits MOSFET Power SOA Timer Optimizes MOSFET Capability Monitors VGS and VDS for MOSFET Health 12V Gate Drive for Lower MOSFET RDS(ON) Parallelable Controllers for Very High Current Levels Available in 24-Lead Narrow SSOP and 24-Pin 4mm × 5mm QFN Packages

40V Low IQ, 3MHz Dual, 2-Phase Synchronous Step-Down Controller with Spread Spectrum Features: Wide Input Voltage Range: 4.5V to 40V Wide Output Voltage Range: 0.8V to 99% • VIN Low Operating IQ: 14μA (14V to 3.3V, Channel 1 On) Spread Spectrum Operation RSENSE or DCR Current Sensing Out-of-Phase Controllers Reduce Required Input Capacitance and Power Supply Induced Noise Programmable Fixed Frequency (100kHz to 3MHz) Phase-Lockable Frequency (100kHz to 3MHz) Selectable Continuous, Pulse-Skipping, or Low Ripple, Burst Mode® Operation at Light Loads Very Low Dropout Operation: 99% Duty Cycle Power Good Output Voltage Monitors Output Overvoltage Protection Internal LDO Powers Gate Drive from VIN or EXTVCC Low Shutdown IQ: 1.5μA Small 28-Lead 4mm × 5mm QFN Package AEC-Q100 Qualified for Automotive Applications

Quad 31.25A or Single 125A Module Regulator with Digital Power System Management Features: Quad Digitally Adjustable Analog Loops with Digital Interface for Control and Monitoring Wide Input Voltage Range: 4.5V to 16V Output Voltage Range: 0.5V to 3.3V ±0.5% Maximum DC Output Error Over Temperature ±4% Current Readback Accuracy: 0°C to 125°C Integrated Input Current Sense Amplifier 400kHz PMBus-Compliant I2C Serial Interface Supports Telemetry Polling Rates Up to 125Hz Integrated 16-Bit ΔΣ ADC Parallel and Current Share Multiple Modules 15mm × 22mm × 8.17mm BGA Package Readable Data: Input and Output Voltages, Currents, and Temperatures Running Peak Values, Uptime, Faults and Warnings Onboard EEPROM Fault Log Record Writable Data and Configurable Parameters: Output Voltage, Voltage Sequencing and Margining Digital Soft-Start/Stop Ramp, Program Analog Loop OV/UV/OT, UVLO, Frequency and Phasing

40V, 7A Ideal Diode Features: Reduces Power Dissipation by Replacing a Power Schottky Diode with No External Components Internal 7A, 21mΩ N-Channel MOSFET 15mV Regulated Forward Voltage 20μA Operating Current, 0.8μA Shutdown Wide 0V to 40V Input Range with VCC > 2.75V Fast Turn-On Minimizes Voltage Droop Fast Reverse Recovery Time Minimizes Reverse Transient Current Smooth Switchover in Diode-OR Applications 16-Lead 2mm × 3mm LQFN Package

Ultrathin Low VIN, 2A Buck-Boost Module Regulator Features: Wide Input Voltage Range: 2.6V to 5.5V Adjustable Output Voltage Range: 1.8V to 5.5V 2A of Continuous Output Current with VIN ≥ VOUT (Buck Mode and Buck-Boost Mode); Minimum 1A Continuous Output Current with VIN < VOUT (Boost Mode). Low Ripple Buck-Boost Architecture Programmable Soft-Start and VIN UVLO Burst Mode IQ 15μA for High Efficiency at Light Loads Ultrathin, Small Surface Mount Footprint 3.5mm × 4mm × 1.25mm LGA Package