Low Noise Amplifier SMT, 350 - 550 MHz Features: Noise Figure: ≤1 dB Output IP3: +38 dBm Gain: 17 dB Very Stable Gain vs. Supply & Temp Single Supply: +5V @ 104 mA 50 Ohm Matched Output

105V, 2.3A Low EMI Synchronous Step-Down Regulator with Fast Current Programming Features: Wide VIN Range: 4.4V to 105V (110V Abs Max) Ultralow EMI/EMC Emissions: CISPR 25 Compliant 2μA IQ When Regulating 48VIN to 3.3VOUT Fast and Accurate Output Current Programming and Monitoring with No External RSENSE Brick Wall Current Limit Low Minimum On-Time: 40ns Wide VOUT Range: 1V to VIN PassThru™/100% Duty Cycle Capable Programmable Fixed Frequency: 200kHz to 2MHz Eight, Pin-Selectable Fixed (1.2V to 15V) or Adjustable Output Voltages Selectable Continuous, Pulse-Skipping, or Low Ripple Burst Mode® Operation at Light Loads PLL Synchronization to External Clock EXTVCC LDO Powers Chip from VOUT = 3.3V to 40V OPTI-LOOP® or Fixed Internal Compensation Input and Output Overvoltage Protection Thermally Enhanced (5mm × 6mm) QFN Package AEC-Q100 Qualification in Process

Isolated High Accuracy Digital Temperature Measurement System with EEPROM Features:5000VRMS Isolated Power and SPI InterfaceDirectly Digitizes 2-, 3- or 4-Wire RTDs, Thermocouples, Thermistors and Diodes10 Flexible Inputs Allow Interchanging SensorsAutomatic Thermocouple Cold Junction CompensationBuilt-In Standard and User-Programmable Coefficients for Thermocouples, RTDs and ThermistorsAutomatic Burn Out, Short-Circuit and Fault DetectionBuffered Inputs Allow External ProtectionSimultaneous 50Hz/60Hz RejectionIncludes 15ppm/°C (Max) ReferenceIncludes Special Protection ModesOn-Chip EEPROM Stores Channel Configuration Data and Custom Coefficients

Ultrathin 1.5A Module Thermoelectric Cooler (TEC) Regulator Features:Built-in Two Zero-Drift, Rail-to-Rail Chopper Amplifiers2.7V to 5.5V Input Voltage Range1.5A Driving Capability1% Accuracy 2.5V Internal Reference OutputIndependent Programmable Heating and Cooling Current LimitTEC Voltage and Current MonitoringProgrammable Maximum TEC VoltageDefault 2MHz Switching FrequencySynchronization from 1.85MHz to 3.25MHzCapable of NTC, PTC and RTD Thermal Sensors3.5mm 4mm 1.3mm LGA Package

8-Channel, 16-Bit Voltage Output SoftSpan DAC Features: Eight independent SoftSpan DAC channels Independently programmable output ranges: 0 V to 5 V, 0 V to 10 V, ±5 V, ±10 V, ±15 V Full 16-bit resolution at all ranges Flexible single- or dual-supply operation Maximum INL error: ±3 LSB Precision 4.096 V reference, ±10 ppm/°C maximum A/B toggle or sinusoidal dither using up to 3 toggle pins Multiplexer for output voltage and load current sense Outputs drive ±55 mA guaranteed 6 mm × 6 mm, 40-lead LFCSP

High Voltage High Current Hot Swap Controller Features: Allows Safe Board Insertion into Live Backplane Wide Operating Voltage Range: 6.5V to 80V Drives Two Gates for High Power Applications Configurable Parallel, Staged Start or Single MOSFET Modes Adjustable Precision Current Limit: 6mV to 20mV Current Foldback Limits MOSFET Power SOA Timer Optimizes MOSFET Capability Monitors VGS and VDS for MOSFET Health 12V Gate Drive for Lower MOSFET RDS(ON) Parallelable Controllers for Very High Current Levels Available in 24-Lead Narrow SSOP and 24-Pin 4mm × 5mm QFN Packages

40V Low IQ, 3MHz Dual, 2-Phase Synchronous Step-Down Controller with Spread Spectrum Features: Wide Input Voltage Range: 4.5V to 40V Wide Output Voltage Range: 0.8V to 99% • VIN Low Operating IQ: 14μA (14V to 3.3V, Channel 1 On) Spread Spectrum Operation RSENSE or DCR Current Sensing Out-of-Phase Controllers Reduce Required Input Capacitance and Power Supply Induced Noise Programmable Fixed Frequency (100kHz to 3MHz) Phase-Lockable Frequency (100kHz to 3MHz) Selectable Continuous, Pulse-Skipping, or Low Ripple, Burst Mode® Operation at Light Loads Very Low Dropout Operation: 99% Duty Cycle Power Good Output Voltage Monitors Output Overvoltage Protection Internal LDO Powers Gate Drive from VIN or EXTVCC Low Shutdown IQ: 1.5μA Small 28-Lead 4mm × 5mm QFN Package AEC-Q100 Qualified for Automotive Applications

Digital Controller for Power Supply Applications with PMBus Interface Features: −40°C to +125°C operation with EEPROM data retention of 15 years at 125°C PMBus Revision 1.2 compliant 32-bit password protection with command masking 64 address selections (16 base addresses, expandable to 64) 6 PWM control signals, 625 ps resolution Duty cycle double update rate Digital control loop (PID + additional pole or zero configurability) Programmable loop filters (CCM, DCM, low/normal temperature) Frequency synchronization Soft start and soft stop functionality Average and peak constant current mode External PN junction temperature sensing 4 GPIOs (2 GPIOs configurable as active clamp snubber PWMs) Fast line voltage feedforward Adaptive dead time compensation for improved efficiency Extended black box data recorder for fault recording See datasheet for additional features

Digital Controller for Power Supply Applications with PMBus Interface Features: −40°C to +125°C operation with EEPROM data retention of 15 years at 125°C PMBus Revision 1.2 compliant 32-bit password protection with command masking 64 address selections (16 base addresses, expandable to 64) 6 PWM control signals, 625 ps resolution Duty cycle double update rate Digital control loop (PID + additional pole or zero configurability) Programmable loop filters (CCM, DCM, low/normal temperature) Frequency synchronization Soft start and soft stop functionality Average and peak constant current mode External PN junction temperature sensing 4 GPIOs (2 GPIOs configurable as active clamp snubber PWMs) Fast line voltage feedforward Adaptive dead time compensation for improved efficiency Extended black box data recorder for fault recording See datasheet for additional features

Isolated Synchronous Flyback Controller with Integrated iCoupler Features: Current mode controller for flyback topology ADP1071-1: programmable LLM or CCM for high VIN applications ADP1071-2: forced CCM operation Programmable slope compensation Integrated 5 kV isolation (wide body SOIC package) or 3.0 kV (LGA package) rated dielectric isolation voltage with Analog Devices, Inc., patented iCoupler technology Wide voltage supply range Primary VDD: up to 60 V (ADP1071-2 only) Secondary VDD2: up to 36 V Integrated 1 A primary side MOSFET driver Integrated 1 A secondary side MOSFET drivers for synchronous rectification Integrated error amplifier and <1% accurate reference voltage Programmable frequency range: 50 kHz to 600 kHz Duty cycle clamp limit 85% Programmable soft start and soft start from precharged load Protection features such as short circuit, output overvoltage, and overtemperature protection Power saving LLM using MODE pin (ADP1071-1only) Cycle by cycle input overcurrent protection Precision enable UVLO with hysteresis Frequency synchronization Safety and regulatory approvals (pending) UL recognition 5000 V rms for 1 minute per UL 1577 (for wide body SOIC package) 3000 V rms for 1 minute per UL 1577 (for LGA package) CSA Component Acceptance Notice 5A VDE certificate of conformity DIN V VDE V 0884-10 (VDE V 0884-10):2006-12 VIORM = 849 V peak (for wide body SOIC package) VIORM = 565 V peak (for LGA package) CQC certification per GB4943.1-2011 Available in 16-lead SOIC_W package and 24 terminal LGA package