2.7 V to 5.25 V, Micropower, 2-Channel, 125 kSPS, 12-Bit ADC in 8-Lead MSOP Features:Specified for VDD of 2.7 V to 5.25 VFlexible power/throughput rate managementShutdown mode: 1 A maxOne or two single-ended inputsSerial interface: SPI/QSPI/MICROWIRE/DSP compatible8-lead narrow SOIC and MSOP packages

Low-Cost, High Speed Differential Driver Features: High Speed: 400 MHz –3 dB Full Power Bandwidth 2000 V/µs Slew Rate Fixed Gain of 2 with No External Components Internal Common-Mode Feedback to Improve Gain and Phase Balance: –60 dB @10 MHz Separate Input to Set the Common-Mode Output Voltage Low Distortion: 68 dB SFDR @ 5 MHz 200 Ω Load Power Supply Range +2.7 V to ±5 V

2.5 V to 5.5 V, 500 A, 2-Wire Interface Quad Voltage Output 10-Bit DAC Features: Four 10-Bit DACS in 10-Lead MicroSOIC Low Power: 600 µA @ 5 V, 500 µA @ 3 V Power-Down to 200 nA @ 5 V, 80nA @ 3 V Guaranteed Monotonic by Design Power-On-Reset to Zero Volts Three Power-Down Functions Double-Buffered Input Logic Output Range: 0 V to VREF 2-Wire (I2C™ Compatible) Data Readback Facility; Software Clear Facility Simultaneous Update via LDAC bit (active low) Temperature Range: −40°C to 105°C

3.0 V to 5.5 V, 12 kV IEC ESD Protected, Half Duplex 500 kbps RS-485 Transceiver Features: TIA/EIA RS-485 compliant over full supply range 3.0 V to 5.5 V operating voltage range on VCC 1.62 V to 5.5 V VIO logic supply option available ESD protection on the bus pins IEC 61000-4-2 ±12 kV contact discharge IEC 61000-4-2 ≥ ±12 kV air discharge HBM: ≥ ±30 kV Full hot swap support (glitch free power-up/power-down) High speed 50 Mbps data rate (ADM3065E/ADM3066E/ADM3067E/ADM3068E) Low speed 500 kbps data rate for long cables (ADM3061E/ADM3062E/ADM3063E) Full receiver short-circuit, open circuit, and bus idle fail-safe Extended temperature range up to 125°C PROFIBUS compliant at VCC ≥ 4.5 V Half duplex and full duplex models available Allows connection of up to 128 transceivers onto the bus Space-saving package options 10-lead, 3 mm × 3 mm LFCSP 8-lead and 10-lead, 3 mm × 3 mm MSOP 8-lead and 14-lead, narrow body SOIC

P Supervisor with Backup Battery Switchover, Watchdog Feature, Power Fail Warning, 4.65V Threshold Voltage, Active Low Reset Features: Precision Supply Voltage Monitor 4.65 V ADM690A/ADM802L/ADM805L 4.40 V ADM692A/ADM802M/ADM805M Reset Assertion Down to 1 V VCC Reset Timeout—200 ms Watchdog Timer—1.6 s 100 mA Quiescent Supply Current Automatic Battery Backup Power Switching Voltage Monitor for Power Fail ±2% Power Fail Accuracy on ADM802L/M Space-Saving MicroSOIC Package (ADM690A)

10 MHz, 14.5 nV/Hz, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifier Features: Power supply rejection ratio (PSRR): 98 dB minimum  Common-mode rejection ratio (CMRR): 95 dB minimum Offset voltage: 120 μV maximum Single-supply operation: 2.7 V to 5.5 V  Dual-supply operation: ±1.35 V to ±2.75 V  Wide bandwidth: 10 MHz  Rail-to-rail input and output  Low noise 2 μV p-p from 0.1 Hz to 10 Hz  14.5 nV/√Hz at 1 kHz  Very low input bias current: 2 pA maximum

16 V, 1 MHz, CMOS RRIO, Dual Op Amp Features: Lower power at high voltage: 290 μA per amplifier typical Low input bias current: 1 pA maximum Wide bandwidth: 1.2 MHz typical Slew rate: 1 V/μs typical Offset voltage drift: 3 μV/°C Single-supply operation: 5 V to 16 V Dual-supply operation: ±2.5 V to ±8 V Unity gain stable Download AD4665-2-KGD Data Sheet. Available As Known Good Die and fully guaranteed to data sheet specifications

10 MHz, 14.5 nV/Hz, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifier Features: Power supply rejection ratio (PSRR): 98 dB minimum  Common-mode rejection ratio (CMRR): 95 dB minimum Offset voltage: 120 μV maximum Single-supply operation: 2.7 V to 5.5 V  Dual-supply operation: ±1.35 V to ±2.75 V  Wide bandwidth: 10 MHz  Rail-to-rail input and output  Low noise 2 μV p-p from 0.1 Hz to 10 Hz  14.5 nV/√Hz at 1 kHz  Very low input bias current: 2 pA maximum

3.1 nV/Hz, 1 mA, 180 MHz,Rail-to-Rail Input/Output Amplifier Features: Low Noise 3.1 nV/√Hz at 100 kHz 0.7 pA/√Hz at 100 kHz Low Distortion (HD2/HD3) -141/-144 dBc at 1 kHz -112/-115 dBc at 100 kHz -84/-79 dBc at 1 MHz High speed performance -3dB bandwidth: 180 MHz Slew Rate: 225 V/µs 0.1% Settling Time: 47 ns Low input offset voltage and drift ±20 / ±125 µV (typical / max) 0.7 / 3.7 µV/°C (typical / max) Low input offset current and drift 8 / 100 nA (typical / max) 30 / 250 pA/°C (typical / max) Rail-to-Rail Input and Output Low quiescent current: Enabled: 1 mA at ±5V Disabled: 2.4 µA at ±5V Wide supply range: 2.7V to 11V Small Packaging: 10-lead 3 mm x 3 mm LFCSP and8-lead MSOP

Dual 55V, EMI Enhanced, Zero Drift, Ultralow Noise,Rail-to-Rail Output Operational Amplifiers Features: Low offset voltage: 5 μV maximum Extremely low offset voltage drift: 22 nV/°C maximum Low voltage noise density:  5.8 nV/√Hz typical  117 nV p-p typical from 0.1 Hz to 10 Hz Low input bias current: 50 pA typical Unity-gain crossover: 3 MHz typical Single-supply operation: input voltage range includes ground and rail-to-rail output Wide range of operating voltages  Single-supply operation: 4.5 V to 55 V  Dual-supply operation: ±2.25 V to ±27.5 V Integrated EMI filters Unity-gain stable Download AD4522-2-KGD Data Sheet. Available As Known Good Die and fully guaranteed to data sheet specifications