Power Management IC Development Tools LTC4088EDE-1 Demo Board- High Efficiency

Power Management IC Development Tools LTC3203B-1 (set for 4.5V or 5V) Demo Bo

Ultralow Noise 1A Switching Regulator Features: Greatly Reduced Conducted and Radiated EMI (<100µVP-P in Typical Application) Low Switching Harmonic Content Independent Control of Switch Voltage and Current Slew Rates Two 1A Current Limited Power Switches Regulates Positive and Negative Voltages 20kHz to 250kHz Oscillator Frequency Easily Synchronized to External Clock Wide Input Voltage Range: 2.7V to 23V Low Shutdown Current: 12µA Typical Easier Layout than with Conventional Switchers Outputs Can Be Forced to 50% Duty Cycle for Unregulated Applications

Dual Channel 4A, 42V, Synchronous Step-Down Silent Switcher 2 with 6.2A Quiescent Current Features: Silent Switcher®2 Architecture: Ultralow EMI on Any PCB Eliminates PCB Layout Sensitivity Internal Bypass Capacitors Reduce Radiated EMI Optional Spread Spectrum Modulation 4A DC from Each Channel Simultaneously Up to 6A on Either Channel Ultralow Quiescent Current Burst Mode® Operation: 6.2μA IQ Regulating 12VIN to 5VOUT1 and 3.3VOUT2 Output Ripple <10mVP-P Forced Continuous Mode Optional External VC Pin: Fast Transient Response and Current Sharing (Extra 50µA IQ/Channel) High Efficiency at High Frequency 94.6% Efficiency at 2A, 5VOUT from 12VIN at 2MHz 93.3% Efficiency at 4A, 5VOUT from 12VIN at 2MHz Fast Minimum Switch-On Time: 40ns Wide Input Voltage Range: 3.0V to 42V Adjustable and Synchronizable: 300kHz to 3MHz Small 4mm × 6mm 32-Pin LQFN Package AEC-Q100 Qualified for Automotive Applications

140V High Efficiency Switching Surge Stopper Features: VOUT Clamp Stops High Voltage Input Surges 100% Duty Cycle Pass-Through Mode During Normal Operation Switches During Overvoltage or Overcurrent Transients and Faults and During Startup High Efficiency Switching Enables Long Duration Surge Protection and High Output Currents Wide VIN Range: 4V to 140V (150V Abs Max) Adjustable Output Voltage Clamp Up to 60V Adjustable Output Overcurrent Protection RSENSE or Inductor DCR Current Sensing Power Inductor Reduces Input EMI in Normal Mode Adjustable Soft-Start for Inrush Current Limiting Programmable Fault Timer Open-Drain Fault Warning Indicator 2.7% Retry Duty Cycle During Faults Adjustable Switching Frequency: 50kHz to to 900kHz Adjustable Input Voltage Turn-On Threshold Adjustable Input Overvoltage Lockout Threshold 20-Pin 4mm × 5mm QFN and TSSOP Packages

Anyside High Voltage Isolated Switch Controller with I2C Command and Telemetry Features: CSA (IEC/UL) Approved, File #255632 Reinforced Insulation Integrated Isolated Power Supply Adjustable Turn-On Ramp Rate and Current Limit I2C/SMBus Interface 10-Bit ADC Monitors Current and Two Uncommitted Channels High Common Mode Transient Immunity: ≥ 30kV/μs Fault Status Alert and Power Good Outputs Independent 3V to 5.5V Logic Supply ±20kV ESD Across the Isolation Barrier Maximum Continuous Working Voltage: 690VRMS 14.6mm Creepage Distance Low Current Shutdown Mode (<10μA) 22mm × 9mm × 5.16mm BGA Package

40A DC/DC Module Regulator Features: Stacked Inductor Acts as Heat Sink Wide Input Voltage Range: 4.7V to 15V 0.6V to 3.3V Output Voltage Range ±1.3% Total DC Output Voltage Error Over Line, Load and Temperature (–40°C to 125°C) Differential Remote Sense Amplifier for Precision Regulation Current Mode Control/Fast Transient Response Frequency Synchronization Parallel Current Sharing (Up to 240A) Internal or External Compensation 88% Efficiency (12VIN, 1VOUT) at 40A Overcurrent Foldback Protection 16mm × 16mm × 7.07mm BGA Package

Dual 25A or Single 50A DC/DC Module Regulator Features: Dual 25A or Single 50A Output Input Voltage Range: 4.5V to 15V Output Voltage Range: 0.6V to 1.8V ±1.5% Maximum Total DC Output Error Over Line, Load and Temperature Differential Remote Sense Amplifier Current Mode Control/Fast Transient Response Adjustable Switching Frequency Frequency Synchronization Overcurrent Foldback Protection Multiphase Parallel Current Sharing with Multiple LTM4650s Up to 300A Internal Temperature Monitor Pin Compatible with the LTM4620 (Dual 13A, Single 26A) and LTM4630 (Dual 18A, Single 36A) Selectable Burst Mode® Operation Soft-Start/Voltage Tracking Output Overvoltage Protection 16mm × 16mm × 5.01mm BGA Package

Power Management IC Development Tools LTC4215 Demoboard - Hot Swap Controller

The HMC976LP3E is a BiCMOS ultra low noise linear voltage regulator. The high Power Supply Rejection Ratio (PSRR) in the 0.1 MHz to 10 MHz range provides excellent rejection of any preceding switching regulator or other power supply noise. The voltage output is ideal for frequency generation subsystems including Hittite’s broad line of PLLs with integrated VCOs. The output voltage can be adjusted lower than the default value by using one external resistor.The output can be set to 5V by grounding the HV pin. The regulator can be powered down by the TTL-compatible Enable input. The HMC976LP3E is housed in a 3x3mm QFN SMT package.Applications Test Instrumentation Military Radios, Radar and ECM Basestation Infrastructure Ultra Low Noise Frequency Generation Fractional-N Synthesizer Supply Mixed-Signal Circuit Supply