40A DC/DC Module Regulator Features: Stacked Inductor Acts as Heat Sink Wide Input Voltage Range: 4.7V to 15V 0.6V to 3.3V Output Voltage Range ±1.3% Total DC Output Voltage Error Over Line, Load and Temperature (–40°C to 125°C) Differential Remote Sense Amplifier for Precision Regulation Current Mode Control/Fast Transient Response Frequency Synchronization Parallel Current Sharing (Up to 240A) Internal or External Compensation 88% Efficiency (12VIN, 1VOUT) at 40A Overcurrent Foldback Protection 16mm × 16mm × 7.07mm BGA Package

36V, 2A Synchronous Step-Up LED Driver Features:±2.5% LED Current Regulation±2% Output Voltage Regulation5000:1 PWM Dimming at 100Hz128:1 Internal PWM DimmingSpread-Spectrum Frequency ModulationSilent Switcher® Architecture for Low EMIOperates in Boost, Buck Mode and Buck-Boost Mode2.8V to 36V Input Voltage RangeUp to 34V LED String Voltage2A, 40V Internal Switches200kHz to 2MHz with SYNC FunctionAnalog or Duty Cycle LED Current ControlOpen/Short LED Protection and Fault IndicationThermally Enhanced 28-Pin (4mm × 5mm) QFN

Dual Output PolyPhase Step-Down DC/DC Voltage Mode Controller with Digital Power System Management Features: PMBus/I2C Compliant Serial Interface Monitor Voltage, Current, Temperature and Faults Digitally Programmable Voltage, Current Limit, Soft-Start/Stop, Sequencing, Margining, AVP and UV/OV Thresholds 3V ≤ VINSNS ≤ 38V, 0.5V ≤ VOUT ≤ 5.25V ±0.5% Output Voltage Accuracy Programmable PWM Frequency or External Clock Synchronization from 250kHz to 1.25MHz Accurate PolyPhase® Current Sharing Internal EEPROM with Fault Logging and ECC IC Supply Range: 3V to 13.2V Resistor or Inductor DCR Current Sensing Optional Resistor Programming for Key Parameters 40-Pin (6mm × 6mm) QFN Package AEC-Q100 Qualified for Automotive Applications

LTPoE++/PoE+/PoE PD Forward/Flyback Controller Features: IEEE802.3af/at and LTPoE++™ 90W Powered Device (PD) with Forward/Flyback Controller LT4276A Supports All of the Following Standards: LTPoE++ 38.7W, 52.7W, 70W and 90W IEEE 802.3at 25.5W Compliant IEEE 802.3af up to 13W Compliant LT4276B is IEEE 802.3at/af Compliant LT4276C is IEEE 802.3af Compliant Superior Surge Protection (100V Absolute Maximum) Wide Junction Temperature Range (–40°C to 125°C) Auxiliary Power Support as Low as 9V No Opto-Isolator Required for Flyback Operation External Hot Swap™ N-Channel MOSFET for Lowest Power Dissipation and Highest System Efficiency >94% End-to-End Efficiency with LT4321 Ideal Bridge Available in a 28-Lead 4mm × 5mm QFN Package

LTPoE++/PoE+/PoE PD Forward/Flyback Controller Features: IEEE802.3af/at and LTPoE++™ 90W Powered Device (PD) with Forward/Flyback Controller LT4276A Supports All of the Following Standards: LTPoE++ 38.7W, 52.7W, 70W and 90W IEEE 802.3at 25.5W Compliant IEEE 802.3af up to 13W Compliant LT4276B is IEEE 802.3at/af Compliant LT4276C is IEEE 802.3af Compliant Superior Surge Protection (100V Absolute Maximum) Wide Junction Temperature Range (–40°C to 125°C) Auxiliary Power Support as Low as 9V No Opto-Isolator Required for Flyback Operation External Hot Swap™ N-Channel MOSFET for Lowest Power Dissipation and Highest System Efficiency >94% End-to-End Efficiency with LT4321 Ideal Bridge Available in a 28-Lead 4mm × 5mm QFN Package

16-/14-/11-Bit 2.7Gsps DACs Features:80dBc SFDR at 50MHz fOUT>68dBc SFDR from DC to 1080MHz fOUT40mA Nominal Full-Scale, ±1V Output Compliant10mA to 60mA Adjustable Full-Scale Current RangeSingle or Dual Port DDR LVDS and DHSTL InterfaceLow Latency (7.5 Cycles for Single Port, 11 Cycles for Dual Port)>78dBc 2-Tone IMD from DC to 1000MHz fOUT–156dBc/Hz Additive Phase Noise at 1MHz Offset for 65MHz fOUT170-Lead (9mm × 15mm) BGA Package

16-/14-/11-Bit 2.7Gsps DACs Features:80dBc SFDR at 50MHz fOUT>68dBc SFDR from DC to 1080MHz fOUT40mA Nominal Full-Scale, ±1V Output Compliant10mA to 60mA Adjustable Full-Scale Current RangeSingle or Dual Port DDR LVDS and DHSTL InterfaceLow Latency (7.5 Cycles for Single Port, 11 Cycles for Dual Port)>78dBc 2-Tone IMD from DC to 1000MHz fOUT–156dBc/Hz Additive Phase Noise at 1MHz Offset for 65MHz fOUT170-Lead (9mm × 15mm) BGA Package

Bridge Sensor Signal Conditioner IC with LIN Interface, Nonlinearity Correction, Temperature Compensation Features:LIN 2.1 compliant interface (bridge sensor signal, temperature)Digitally programmable gain and offset voltage adjustmentGain range from 2.94 V/V to 971.10 V/VSensor temperature compensation (first- or second-order)Sensor nonlinearity correction (first- or second-order)Internal or external temperature sensor compensationEEPROM nonvolatile memory for calibration dataHigh system accuracy: 0.1% FSR over temperatureEMC and EMI protectionFault protection for open circuits and short circuits4 mm 4 mm, 20-lead LFCSP6 V to 18 V supply operation40C to +150C operating temperature rangeAEC-Q100 qualified for automotive applications

16-Bit, 15 MSPS, Module Data Acquisition Solution Features: Integrated fully differential ADC driver with signal scaling Wide input common range High common-mode rejection Single-ended to differential conversion 2.048 V input range with 4.096 V REFBUF Critical passive components 0.005% precision matched resistor array for FDA 9 mm × 9 mm, 0.8 mm pitch, 100-ball BGA package 4× footprint reduction versus discrete solution Low power, dynamic power scaling, power-down mode 143 mW typical at 15 MSPS Throughput: 15 MSPS, no pipeline delay INL: 0.4 LSB typical, 1 LSB maximum SINAD: 89 dB typical at 1 kHz THD: 115 dB at 1 kHz, 106 dB at 400 kHz Gain error: 0.005% FS typical Gain error drift: 1 ppm/C maximum On-board reference buffer with VCMO generation Serial LVDS interface Wide operating temperature range: 40C to +85C

18-Bit, 15 MSPS, Module Data Acquisition Solution Features: Integrated fully differential ADC driver with signal scaling Wide input common-mode voltage range High common-mode rejection Single-ended to differential conversion Pin selectable input range with overrange Input ranges with 4.096 V REFBUF: ±10 V, ±5 V, ±4.096 V, ±2.5 V, and ±1.5 V Gain/attenuation options: 0.37, 0.73, 0.87, 1.38, and 2.25 Critical passive components 0.005% precision matched resistor array for FDA 9 mm × 9 mm, 0.8 mm pitch, 100-ball CSP_BGA package 2.5× footprint reduction vs. discrete solution Low power, dynamic power scaling, power-down mode 143 mW typical at 15 MSPS Throughput: 15 MSPS, no pipeline delay INL error: ±3.1 ppm typical, ±6.2 ppm maximum (Gain = 0.73, gain = 0.87, gain = 1.38, gain = 2.25) SINAD: 90.4 dB typical at 20 kHz (gain = 0.73) THD: −117 dB at 1 kHz, −110 dB at 100 kHz (gain = 0.73) Gain error: ±0.005%FS typical Gain error drift: ±0.13 ppm/°C typical On-board reference buffer with VCMO generation Serial LVDS interface Wide operating temperature range: −40°C to +85°C