Single-Supply, Multichannel, 125 kSPS, 24-Bit, Sigma-Delta ADC with 10 V Inputs Features:24-bit ADC with integrated AFEFast and flexible output rate: 2.5 SPS to 125 kSPSChannel scan data rate of 24,845 SPS per channel (40.25 s settling)85 dB common mode rejection of 50 Hz and 60 Hz at 20 SPS per channel10 V inputs, either 8 differential or 16 single-endedVIN pin absolute maximum rating 65 VAbsolute input pin voltage up to 20 VMinimum 1 M impedanceOn-chip 2.5 V reference0.12% initial accuracy at 25C, 5 ppm/C (typical) driftInternal or external clockPower suppliesAVDD = 4.5 V to 5.5 VIOVDD = 2 V to 5.5 VTotal current consumption AVDD + IOVDD (IDD) = 10.4 mATemperature range: 40C to +105C3-wire or 4-wire serial digital interface (Schmitt trigger on SCLK)SPI, QSPI, MICROWIRE, and DSP compatible

32 A, Ultra Low Power, 24-Bit Sigma-Delta ADC with Integrated PGA and FIFO Features: Ultralow current consumption (typical): 32 μA: continuous conversion mode (gain = 128) 5 μA: duty cycling mode (ratio = 1/16) 0.5 μA: standby mode 0.1 μA: power-down mode Built-in features for system level power savings: Current saving duty cycle ratio: 1/4 or 1/16 Smart sequencer and per channel configuration minimizes host processor load Deep embedded FIFO minimizes host processor load (depth of 256 samples) Autonomous FIFO interrupt functionality, threshold detection Single supply as low as 1.71 V increasing battery length RMS noise: 25 nV rms at 1.17 SPS (gain = 128) – 48 nV/√Hz Up to 22 noise free bits (gain = 1) Output data rate: 1.17 SPS to 2.4 kSPS Operates from 1.71 V to 3.6 V single supply or ±1.8 V split supplies Band gap reference with 15 ppm/°C maximum drift PGA with rail-to-rail analog input Adaptable sensor interfacing functionality: Matched programmable excitation currents for RTDs On-chip bias voltage generator for thermocouples Low-side power switch for bridge transducers Sensor open wire detection Internal temperature sensor and oscillator Self and system calibration Flexible filter options Simultaneous 50 Hz/60 Hz rejection (on selected filter options) General-purpose outputs Diagnostic functionality Crosspoint multiplexed inputs 8 differential/16 pseudo differential inputs 5 MHz SPI (3-wire or 4-wire) Available in 35-ball, 2.74 mm × 3.6 mm WLCSP Temperature range: −40°C to +105°C

16-Bit, 16-Channel, 500 kSPS/1 MSPS, Easy Drive Multiplexed SAR ADC Features: Easy Drive Reduced analog input and reference drive requirements On-chip reference buffer (WLCSP only) Overvoltage protection up to 5 mA on each analog input Long acquisition phase, ≥71.5% (715 ns/1000 ns) of cycle time at 1 MSPS High performance Sample rate: 500 kSPS (AD4695) or 1 MSPS (AD4696) INL: ±1.0 LSB maximum Guaranteed 16-bit, no missing codes SINAD: 93 dB typical, fIN = 1 kHz Oversampled dynamic range: 111.2 dB, OSR = 64 Small footprint, high channel density 32-lead 5 mm × 5 mm LFCSP 36-ball 2.96 mm × 2.96 mm WLCSP Easy Drive features support system level designs with fewer components Enhanced digital functionality First conversion accurate, no latency or pipeline delay Fast conversion time and dual-/quad-SDO modes allow low SPI clock rates Customizable channel sequencer On-chip oversampling and decimation Threshold detection alerts Offset and gain correction Autonomous conversion (autocycle) mode 1.14 V to 1.98 V logic SPI Low power 8 mW at fS = 1 MSPS and 4 mW at fS = 500 kSPS 4 μW standby power dissipation with the internal LDO disabled Internal LDO enables 3.15 V to 5.5 V, single analog supply operation Wide operating temperature range: −40°C to +125°C

16-Bit, 16-Channel, 500 kSPS/1 MSPS, Easy Drive Multiplexed SAR ADC Features: Easy Drive Reduced analog input and reference drive requirements On-chip reference buffer (WLCSP only) Overvoltage protection up to 5 mA on each analog input Long acquisition phase, ≥71.5% (715 ns/1000 ns) of cycle time at 1 MSPS High performance Sample rate: 500 kSPS (AD4695) or 1 MSPS (AD4696) INL: ±1.0 LSB maximum Guaranteed 16-bit, no missing codes SINAD: 93 dB typical, fIN = 1 kHz Oversampled dynamic range: 111.2 dB, OSR = 64 Small footprint, high channel density 32-lead 5 mm × 5 mm LFCSP 36-ball 2.96 mm × 2.96 mm WLCSP Easy Drive features support system level designs with fewer components Enhanced digital functionality First conversion accurate, no latency or pipeline delay Fast conversion time and dual-/quad-SDO modes allow low SPI clock rates Customizable channel sequencer On-chip oversampling and decimation Threshold detection alerts Offset and gain correction Autonomous conversion (autocycle) mode 1.14 V to 1.98 V logic SPI Low power 8 mW at fS = 1 MSPS and 4 mW at fS = 500 kSPS 4 μW standby power dissipation with the internal LDO disabled Internal LDO enables 3.15 V to 5.5 V, single analog supply operation Wide operating temperature range: −40°C to +125°C

256 Position SPI/I2C Selectable Digital Potentiometer Features: 256-position End-to-end resistance 5 kΩ, 10 kΩ, 50 kΩ, 100 kΩ Compact MSOP-10 (3 mm × 4.9 mm) package Pin selectable SPI/I2C compatible interface Extra package address decode pin AD0 Full read/write of wiper register Power-on preset to midscale Single supply 2.7 V to 5.5 V Low temperature coefficient 45 ppm/°C Low power, IDD = 8 μA Wide operating temperature −40°C to +125°C SDO output allows multiple device daisy-chaining Evaluation board available

MxFE Quad, 16-Bit, 12GSPS RFDAC and Quad, 12-Bit, 4GSPS RFADC Features: Flexible, reconfigurable common platform design 4 DACs and 4 ADCs (4D4A) Supports single, dual, and quad band Datapaths and DSP blocks are fully bypassable DAC to ADC sample rate ratios of 1, 2, 3, and 4 On-chip PLL with multichip synchronization External RFCLK input option for off-chip PLL Maximum DAC sample rate up to 12 GSPS Maximum data rate up to 12 GSPS using JESD204C Useable analog bandwidth to 8 GHz Maximum ADC sample rate up to 4 GSPS Maximum data rate up to 4 GSPS using JESD204C 7.5 GHz analog input full power bandwidth (3 dB) ADC ac performance at 4 GSPS, input at 2.7 GHz, 1 dBFS Full-scale input voltage: 1.4 V p-p Noise density: 147.5 dBFS/Hz Noise figure: 26.8 dB HD2: 67 dBFS HD3: 73 dBFS Worst other (excluding HD2 and HD3): 79 dBFS at 2.7 GHz DAC ac performance at 12 GSPS Full-scale output current range: 6.43 mA to 37.75 mA Two-tone IMD3 (7 dBFS per tone): 78.9 dBc NSD, single-tone at 3.7 GHz: 155.1 dBc/Hz SFDR, single-tone at 3.7 GHz: 70 dBc SERDES JESD204B/JESD204C interface, 16 lanes up to 24.75 Gbps 8 lanes JESD204B/C transmitter (JTx) and 8 lanes JESD204B/C receiver Rx (JRx) JESD204B compliance with the maximum 15.5 Gbps JESD204C compliance with the maximum 24.75 Gbps Supports real or complex digital data (8-, 12-, 16-, or 24-bit) Versatile digital features Configurable or by-passable DDCs and DUCs 8 fine complex DUCs and 4 coarse complex DUCs 8 fine complex DDCs and 4 coarse complex DDCs 48-bit NCO per DUC or DDC Programmable 192-tap PFIR filter for receive equalization Supports 4 different profile settings loaded via GPIO Programmable delay per datapath Receive AGC support Fast detect with low latency for fast AGC control Signal monitor for slow AGC control Transmit DPD support Fine DUC channel gain control and delay adjust Coarse DDC delay adjust for DPD observation path Auxiliary features Fast frequency hopping and direct digital synthesis (DDS) Low latency loopback mode (receive datapath data can be routed to the transmit datapaths) ADC clock driver with selectable divide ratios Power amplifier downstream protection circuitry On-chip temperature monitoring unit Flexible GPIO pins TDD power savings option and sharing ADCs 15 mm × 15 mm, 324-ball BGA with 0.8 mm pitch

8-Bit, 1 GSPS, JESD204B, Quad Analog-to-Digital Converter Features:JESD204B (Subclass 1 and Subclass 0) coded serial digital outputs Lane rates up to 15 Gbps 1.6 W total power at 1 GSPS 400 mW per ADC channel SFDR: 71 dBFS at 611 MHz (1.44 V p-p input range) SNR: 48.6 dBFS at 611 MHz (1.44 V p-p input range) SINAD: 48.5 dBFS at 611 MHz (1.44 V p-p input range) 0.9 V, 1.8 V, and 2.5 V dc supply operation No missing codes Internal ADC voltage reference Analog input buffer On-chip dithering to improve small signal linearityFlexible differential input range 1.44 V p-p to 2.16 V p-p (1.44 V p-p default) 1.4 GHz analog input full power bandwidth Fast detect bits for efficient AGC implementation Differential clock input Integer clock divide by 1, 2, 4, or 8 On-chip temperature diode Flexible JESD204B lane configurations

Quad, Low Power, 12-Bit, 180 MSPS, Digital-to-Analog Converter and Waveform Generator Features: Highly integrated quad DAC On-chip 4096 × 12-bit pattern memory On-chip DDS Power dissipation at 3.3 V, 4 mA output typical 315.25 mW at 180 MSPS Power-down mode: <5 mW at 3.3 V Supply voltage: 1.8 V to 3.3 V SFDR to Nyquist: 86 dBc at 10 MHz output Phase noise at 1 kHz offset, 180 MSPS, 4 mA: −140 dBc/Hz Differential full-scale current outputs: 8 mA maximum at 3.3 V Small footprint, 5 mm × 5 mm with 3.5 mm × 3.6 mm exposed paddle, 32-lead LFCSP RoHS compliant package

Precision Amplifiers Quad Precision 36V,Low Power RRO

ADC, 14BIT, 65MSPS, LQFP-52;