Multi-Sensor High Accuracy Digital Temperature Measurement System Features: Directly Digitize RTDs, Thermocouples, Thermistors, and Diodes Single 2.85V to 5.25V Supply Results Reported in °C or °F 20 Flexible Inputs Allow Interchanging Sensors Automatic Thermocouple Cold Junction Compensation Built-In Standard and User-Programmable Coefficients for Thermocouples, RTDs and Thermistors Configurable 2-, 3- or 4-Wire RTD Configurations Measures Negative Thermocouple Voltages Automatic Burn Out, Short-Circuit and Fault Detection Buffered Inputs Allow External Protection Simultaneous 50Hz/60Hz Rejection Includes 10ppm/°C (max) Reference (I-Grade)

25V, 600mA Buck-Boost DC/DC Converter with 1.6A Quiescent Current Features: Regulates VOUT Above, Below or Equal to VIN Wide VIN Range: 2.4V to 25V, <1V to 25V (Using EXTVCC Input) VOUT Range: 1V to 25V Adjustable Output Voltage (LTC3130) Four Selectable Fixed Output Voltages (LTC3130-1) 1.2µA No-Load Input Current in Burst Mode® Operation (VIN = 12V, VOUT = 5V) 600mA Output Current in Buck Mode Pin-Selectable 850mA/450mA Current Limit (LTC3130) Up to 95% Efficiency Pin-Selectable Burst Mode Operation 1.2MHz Ultralow Noise PWM Frequency Accurate RUN Pin Threshold n Power Good Indicator Programmable Maximum Power Point Control IQ = 500nA in Shutdown Thermally-Enhanced 20-Lead 3mm × 4mm QFN and 16-Lead MSOP Packages

60VIN, 3A Silent Switcher Module Regulator Features: Complete Step-Down Switch Mode Power Supply Low Noise Silent Switcher® Architecture Wide Input Voltage Range: 3.4V to 60V Wide Output Voltage Range: 0.8V to 15V 3A Continuous Output Current, 5A Peak Parallelable for Increased Output Current Selectable Switching Frequency: 200kHz to 3MHz Programmable Soft-Start 6.25mm × 9mm × 3.32mm BGA Package

60V Low IQ, Dual, 2-Phase Synchronous Step-Down DC/DC Controller Features: Wide VIN Range: 4.5V to 60V (65V Abs Max) Wide Output Voltage Range: 0.8V ≤ VOUT ≤ 99% • VIN Adjustable Gate Drive Level 5V to 10V (OPTI-DRIVE) No External Bootstrap Diodes Required Low Operating IQ: 29μA (One Channel On) Selectable Gate Drive UVLO Thresholds Out-of-Phase Operation Reduces Required Input Capacitance and Power Supply Induced Noise Phase-Lockable Frequency: 75kHz to 850kHz Selectable Continuous, Pulse Skipping or Low Ripple Burst Mode® Operation at Light Loads Selectable Current Limit (LTC3892/LTC3892-2) Very Low Dropout Operation: 99% Duty Cycle Power Good Output Voltage Monitors (LTC3892/LTC3892-2) Low Shutdown IQ: 3.6μA Small 32-Lead 5mm × 5mm QFN Package (LTC3892/LTC3892-2) or TSSOP Package (LTC3892-1)

Dual Channel 2A, 42V,Synchronous Step-Down Silent Switcher 2with 6.2A Quiescent Current Features: Silent Switcher®2 Architecture: Ultralow EMI on Any PCB Eliminates PCB Layout Sensitivity Internal Bypass Capacitors Reduce Radiated EMI Optional Spread Spectrum Modulation 2A DC from Each Channel Simultaneously Up to 3A on Either Channel Ultralow Quiescent Current Burst Mode® Operation: 6.2μA IQ Regulating 12VIN to 5VOUT1 and 3.3VOUT2 Output Ripple < 10mVP–P Optional External VC Pin: Fast Transient Response Forced Continuous Mode High Efficiency at High Frequency 94.1% Efficiency at 1A, 5VOUT from 12VIN at 2MHz Pin-Selectable Fixed Output Voltages: 5V, 3.3V, 1.8V Fast Minimum Switch-On Time: 30ns Wide Input Voltage Range: 3.0V to 42V Adjustable and Synchronizable: 300kHz to 3MHz Fixed Output Pin Strap Options Internal 2MHz fSW with Fast Internal Compensation Small 4mm × 3mm 20-Pin LQFN Package AEC-Q100 Qualified for Automotive Applications

>10 W (42 dBm), 2.7 GHz to 3.8 GHz, GaN Power Amplifier Features: High small signal gain: 34.5 dB typical High output power: 42 dBm typical at PIN = 18 dBm High PAE: 55% typical at PIN = 18 dBm Frequency range: 2.7 GHz to 3.8 GHz Supply voltage: VDD = 28 V at a quiescent current of 150 mA 5 mm × 5 mm, 32-lead LFCSP_CAV package

Quad-Channel, Software Configurable Input and Output Features: Quad-channel software configurable input/output circuit Screw terminals tolerant to ±40 V dc Line protectors to block power from the screw terminals to supplies User configurable modes Voltage input Current input Voltage output Current output Digital input RTD measurement Internal 16-bit, Σ- ADC with optional 50 Hz and 60 Hz rejection 13-bit monotonic DACs Charge pump for true zero voltage output HART-compatible Internal temperature sensor, ±5°C accuracy On-chip diagnostics including open circuit and short-circuit detection SPI-compatible Temperature range: −40°C to +105°C 64-lead LFCSP

High Performance, Multiphase Energy, and Power Quality Measurement IC Features: 7 high performance ADCs 101 dB SNR Wide input voltage range: ±1 V, 707 mV rms FS at gain = 1 Differential inputs ±25 ppm/°C maximum channel drift (including ADC, internal VREF, PGA drift) enabling 10000:1 dynamic input range Class 0.2 metrology with standard external components Power quality measurements Enables implementation of IEC 61000-4-30 Class S VRMS ½, IRMS ½ rms voltage refreshed each half cycle 10 cycle rms/12 cycle rms Dip and swell monitors Line frequency—one per phase Zero crossing, zero-crossing timeout Phase angle measurements Supports CTs and Rogowski coil (di/dt) sensors Multiple range phase/gain compensation for CTs Digital integrator for Rogowski coils Flexible waveform buffer Able to resample waveform to ensure 128 points per line cycle for ease of external harmonic analysis Events, such as dip and swell, can trigger waveform storage Simplifies data collection for IEC 61000-4-7 harmonic analysis Advanced metrology feature set Total and fundamental active power, volt amperes reactive (VAR), volt amperes (VA), watthour, VAR hour, and VA hour Total and fundamental IRMS, VRMS Total harmonic distortion Power factor Supports active energy standards: IEC 62053-21 and IEC 62053-22; EN50470-3; OIML R46; and ANSI C12.20 Supports reactive energy standards: IEC 62053-23, IEC 62053-24 High speed communication port: 20 MHz serial port interface (SPI) Integrated temperature sensor with 12-bit successive approximation register (SAR) ADC ±3°C accuracy from −40°C to +85°C

High Voltage, Latch-Up Proof, 16-Channel Multiplexer Features: Latch-up proof 3.5 pF off source capacitance 64 pF off drain capacitance 0.35 pC typical charge injection ±0.02 nA on channel leakage Low on resistance: 155 typical ±9 V to ±22 V dual-supply operation 9 V to 40 V single-supply operation VSS to VDD analog signal range Human body model (HBM) ESD rating - 8 kV all other pins

Dual Channel, 16-Bit, 16 MUPS, Multispan, Multi-IO SPI DAC Features: 16-bit resolution 16 MUPS single channel rate in fast mode 11 MUPS single channel rate in precision mode 78 ns small signal settling time to 0.1% accuracy 100 ns large signal settling time to 0.1% accuracy Ultrasmall glitch: <50 pV×s Ultralow latency: 5 ns THD: −105 dB at 1 kHz Highly configurable output voltage span and offset 1.2 V and 1.8 V logic level compatible Single (classic) and dual SPI modes Multiple error detectors, both analog and digital domains 2.5 V internal voltage reference, 10 ppm/°C maximum temperature coefficient Small package: 4 mm × 4 mm LFCSP