The HMC472ALP4E are broadband 6-bit GaAs IC digital attenuators in low cost leadless surface mount packages. This single positive control line per bit digital attenuator incorporates off chip AC ground capacitors for near DC operation, making it suitable for a wide variety of RF and IF applications. Covering DC to 3.8 GHz, the insertion loss is less than 2.0 dB typical. The attenuator bit values are 0.5 (LSB), 1, 2, 4, 8, and 16 dB for a total attenuation of 31.5 dB. Attenuation accuracy is excellent at ? 0.25 dB typical step error with an IIP3 of +54 dBm. Six TTL/CMOS control inputs are used to select each attenuation state. A single Vdd bias of +5V is required.APPLICATIONSThe HMC472ALP4E is ideal for: 3G Infrastructure & access points? Cellular/3G, LTE & UMB WiMAX, WiBN & Fixed Wireless? Test Equipment and Sensors GSM, WCDMA & TD-SCDMA

Quad IF Receiver Features: 11-bit 200MSPS output data rate per channel Integrated Noise Shaping Requantizer (NSR) Performance with NSR enabled: SNR: 75.5 dBFS in 40 MHz band to 70 MHz @ 185 MSPS SNR: 73.7 dBFS in 60 MHz band to 70 MHz @ 185 MSPS Performance with NSR disabled: SNR: 66.5 dBFS to 70 MHz @ 185 MSPS SFDR: 83 dBc to 70 MHz @ 185 MSPS Low power: 1.2 W @ 185 MSPS 1.8 V analog supply operation 1.8 V LVDS (ANSI-644 levels) output 1-to-8 integer clock divider Internal ADC voltage reference 1.75 V p-p analog input range (programmable to 2.0 V p-p) Differential analog inputs with 800 MHz bandwidth See data sheet for additional features

Cascadable IF VGAs with Programmable RMS Detectors

High IP3, 700 MHz to 2800 MHz, Double Balanced, Passive Mixer, IF Amplifier, and Wideband LO Amplifier

Dual Power PLL Frequency Synthesizer Features: IDD total, 7.5 mA Bandwidth RF/IF, 2.4 GHz/1.0 GHz 2.7 V to 3.3 V power supply Separate VP allows extended tuning voltage Programmable dual modulus prescaler RF and IF: 8/9, 16/17, 32/33, 64/65 Programmable charge pump currents 3-wire serial interface Analog and digital lock detect Fastlock mode Power-down mode 20-lead TSSOP and 20-lead LFCSP packages

The HMC618ALP3E is a GaAs pHEMT MMIC Low Noise Amplifier that is ideal for Cellular/3G and LTE/WiMAX/4G basestation front-end receivers operating between 1.2 - 2.2 GHz. The amplifier has been optimized to provide 0.75 dB noise figure, 19 dB gain and +36 dBm output IP3 from a single supply of +5V. Input and output return losses are excellent and the LNA requires minimal external matching and bias decoupling components. The HMC618ALP3E shares the same package and pinout with the HMC617LP3E 0.55 - 1.2 GHz LNA. The HMC618ALP3E can be biased with +3V to +5V and features an externally adjustable supply current which allows the designer to tailor the linearity performance of the LNA for each application. The HMC618ALP3E offers improved noise figure versus the previously released HMC375LP3(E) and the HMC382LP3(E).Applications Cellular/3G and LTE/WiMAX/4G BTS & Infrastructure Repeaters and Femto Cells Public Safety Radio

The ADL5501 is a mean-responding power detector for use in high frequency receiver and transmitter signal chains from 50 MHz to 6 GHz. It is easy to apply, requiring only a single supply between 2.7 V and 5.5 V and a power supply decoupling capacitor. The input is internally ac-coupled and has a nominal input impedance of 50 ?. The output is a linear-responding dc voltage with a conversion gain of 6.3 V/V rms at 900 MHz.The ADL5501 is intended for true power measurement of simple and complex waveforms. The device is particularly useful for measuring high crest factor (high peak-to-rms ratio) signals, such as CDMA-, CDMA2000-, W-CDMA-, and QPSK-/QAM-based OFDM waveforms. The on-chip modulation filter provides adequate averaging for most waveforms.The on-chip, 100 ? series resistance at the output, combined with an external shunt capacitor, creates a low-pass filter response that reduces the residual ripple in the dc output voltage. For more complex waveforms, an external capacitor at the FLTR pin can be used for supplementary signal demodulation.The ADL5501 offers excellent temperature stability across a 30 dB range and near 0 dB measurement error across temperature over the top portion of the dynamic range. In addition to its temperature stability, the ADL5501 offers low process variations that further reduce calibration complexity.The ADL5501 operates from ?40?C to +85?C and is available in a small 6-lead SC-70 package. It is fabricated on a proprietary high fT silicon bipolar process.ApplicationsMeasurement of CDMA-, CDMA2000-, W-CDMA-, and QPSK-/ QAM-based OFDM, and other complex modulationwaveforms RF transmitter or receiver power measurement

The ADRF5024 is a reflective, single-pole double-throw (SPDT) switch manufactured in the silicon process.This switch operates from 100 MHz to 44 GHz with better than 1.7 dB of insertion loss and 35 dB of isolation. The ADRF5024 has an radio frequency (RF) input power handling capability of 27 dBm for both the through path and hot switching.The ADRF5024 draws a low current of 14 ?A on the positive supply of +3.3 V and 120 ?A on negative supply of ?3.3 V. The device employs complementary metal-oxide semiconductor (CMOS)-/low voltage transistor to transistor logic (LVTTL)compatible controls.The ADRF5024 is pin-compatible with the ADRF5025, low frequency cutoff version, which operates from 9 kHz to 44 GHz.The ADRF5024 RF ports are designed to match a characteristic impedance of 50 ?. For ultrawideband products, impedance matching on the RF transmission lines can further optimize high frequency insertion loss and return loss characteristics. Refer to the Electrical Specifications section, Typical Performance Characteristics section, and Applications Information section for more details.The ADRF5024 comes in a 2.25 mm ? 2.25 mm, 12-terminal, RoHS-compliant, land grid array (LGA) package and can operate between ?40?C to +105?C.The ADRF5024-EP supports defense and aerospace applications (AQEC).Applications Industrial scanners Test and instrumentation Cellular infrastructure: 5G mmWave Military radios, radars, electronic counter measures (ECMs) Microwave radios and very small aperture terminals (VSATs)

Phase Locked Loops - PLL Phase-Locked Oscillator , 14.7-15.4GHz

Attenuators 1 dB LSB 5Bit dig atten Chip 0.1-40 GHz