25A, Dual PolyPhase Regulator with Digital Power System Management Features: PMBus/I2C Compliant Serial Interface Telemetry Read-Back Includes VIN, IIN, VOUT, IOUT, Temperature and Faults Programmable Voltage, Current Limit, Digital Soft-Start/Stop, Sequencing, Margining, OV/UV/OC Sub-Milliohm DCR Current Sensing Digitally Adjustable Loop Compensation Parameters 0.5% Output Voltage Accuracy Over Temperature Integrated Input Current Sense Amplifier Internal EEPROM with ECC and Fault Logging Integrated N-Channel MOSFET Gate Drivers

3GHz to 20GHz Microwave Mixer with Wideband DC to 6GHz IF Features:Integrated LO Buffer: 0dBm LO Drive50 Wideband Matched RF and LO PortsWide IF Bandwidth: DC to 6GHzUpconversion or DownconversionHigh IIP3:+22.5dBm at 10GHz+18.3dBm at 17GHz+14.6dBm Input P1dB at 10GHz8dB Conversion Loss at 10GHz3.3V/132mA SupplyFast Turn ON/OFF for TDD Operation3mm × 2mm, 12-Lead QFN Package

Very Low Noise, Low Distortion Active RC Quad Universal Filter Features: Continuous Time—No Clock Four 2nd Order Filter Sections, 20kHz to 300kHz Center Frequency Butterworth, Chebyshev, Elliptic or Equiripple Delay Response Lowpass, Bandpass, Highpass Responses 99dB Typical S/N, ±5V Supply (Q = 1) 93dB Typical S/N, Single 5V Supply (Q = 1) Rail-to-Rail Input and Output Voltages DC Accurate to 3mV (Typ) ±0.5% Typical Center Frequency Accuracy “Zero-Power” Shutdown Mode Single or Dual Supply, 5V to 10V Total Resistor-Programmable fO, Q, Gain

Anyside High Voltage Isolated Switch Controller with I2C Command and Telemetry Features: CSA (IEC/UL) Approved, File #255632 Reinforced Insulation Integrated Isolated Power Supply Adjustable Turn-On Ramp Rate and Current Limit I2C/SMBus Interface 10-Bit ADC Monitors Current and Two Uncommitted Channels High Common Mode Transient Immunity: ≥ 30kV/μs Fault Status Alert and Power Good Outputs Independent 3V to 5.5V Logic Supply ±20kV ESD Across the Isolation Barrier Maximum Continuous Working Voltage: 690VRMS 14.6mm Creepage Distance Low Current Shutdown Mode (<10μA) 22mm × 9mm × 5.16mm BGA Package

PolyPhase, High Efficiency, Synchronous Step-Down Switching Regulator Features: Dual Controller Operates from One to Twelve Phases Reduces Required Input Capacitance and Power Supply Induced Noise Current Mode Control Ensures Current Sharing Phase-Lockable Fixed Frequency: 150kHz to 300kHz 1.8MHz Effective Switching Frequency True Remote Sensing Differential Amplifier OPTI-LOOP™ Compensation Reduces COUT ±1% Output Voltage Accuracy Power Good Output Voltage Monitor (LTC1629-PG) Wide VIN Range: 4V to 36V Operation Very Low Dropout Operation: 99% Duty Cycle Adjustable Soft-Start Current Ramping Internal Current Foldback Plus Shutdown Timer Overvoltage Soft-Latch Eliminates Nuisance Trips Micropower Shutdown Available in 28-Lead SSOP Package

Isolated Module DC DC Converter 2 Output 2.5 ~ 13V 1.2 ~ 12V 440mA, 300mA 3.1V - 32V Input

2 A/1.2 A DC-to-DC Switching Regulator with Independent Positive and Negative Outputs Features: Wide input supply voltage range: 2.85 V to 15 V Generates well regulated, independently resistor programmable VPOS and VNEG outputs Boost regulator to generate VPOS output Adjustable positive output to 39 V Integrated 2.0 A main switch Optional single-ended primary-inductor converter (SEPIC) configuration for automatic step-up/step-down Inverting regulator to generate VNEG output Adjustable negative output to VIN − 39 V Integrated 1.2 A main switch True shutdown for both positive and negative outputs 1.2 MHz/2.4 MHz switching frequency with optional external frequency synchronization from 1.0 MHz to 2.6 MHz Resistor programmable soft start timer Slew rate control for lower system noise Individual precision enable and flexible start-up sequence control for symmetric start, VPOS first, or VNEG first Out-of-phase operation UVLO, OCP, OVP, and TSD protection 4 mm × 4 mm, 20-lead LFCSP and 20-lead TSSOP −40°C to +125°C junction temperature range Supported by the ADIsimPower tool set

Isolated Module DC DC Converter 2 Output 2.5 ~ 13V 1.2 ~ 12V - 440mA, 300mA 3.1V - 32V Input

1.5A, 500kHz Step-Down Switching Regulators Features: Constant 500kHz Switching Frequency Uses All Surface Mount Components Inductor Size Reduced to 5μH Easily Synchronizable Saturating Switch Design: 0.4Ω Effective Supply Current: 2.5mA Shutdown Current: 20μA Cycle-by-Cycle Current Limiting

High Power Step-Down Synchronous DC/DC Controllers for Low Voltage Operation Features: VOUT as Low as 0.6V High Power Switching Regulator Controller for 3.3V-5V to 0.6V-3.xV Step-Down Applications No Current Sense Resistor Required Low Input Supply Voltage Range: 3V to 8V Maximum Duty Cycle >91% Over Temperature All N-Channel External MOSFETs Excellent Output Regulation: ±1% Over Line, Load and Temperature Variations High Efficiency: Over 95% Possible Adjustable or Fixed 2.5V Output (LTC3832) Programmable Fixed Frequency Operation: 100kHz to 500kHz External Clock Synchronization Soft-Start Low Shutdown Current: <10µA Overtemperature Protection Available in SO-8 and SSOP-16 Packages